Which TM for throttle pedal/linkage/IP set-up please?

[blisters13]

Hi:

I have looked thru a couple of TM's but have not found instructions for zeroing and setting the throttle pedal/linkage/injector pump/fuel density compensator.

My engine seems underpowered, but before I melt a piston/blow it up, I want to make sure it's all set to factory specs.

I am working on a pyrometer install as well.

I would also appreciate direction to setting the intake/exhaust valves.

Thanks in advance!

-Ken

P.S.: All new fuel filters and fresh #2 diesel in the tank. Air filter is near-new and recently blown clean.

 

[Warthog]

I don't have it handy but the old LDS Troubleshooting manual has some good info. It has been posted before.

 

[eagle4g63]

Look in here:
http://www.jatonkam35s.com/DeuceTechnicalManuals/troubleshooting the multifuel engine.pdf

This is how I set up my valves.......intake-.010 ........exhaust-.025 ......it will tell you which ones to do and what order, there is a chart in this TM

 

[DieselBob]

Try here starting on page 3-70 for the accelerator adjustments.

http://test.steelsoldiers.com/upload/M35/TM9-2320-361-20.pdf

 

[blisters13]

Look in here:
http://www.jatonkam35s.com/DeuceTechnicalManuals/troubleshooting the multifuel engine.pdf

This is how I set up my valves.......intake-.010 ........exhaust-.025 ......it will tell you which ones to do and what order, there is a chart in this TM

Mine has a White LDT-465-1C and the plate has the same gap specs. Thanks for the link!

 

[blisters13]

Try here starting on page 3-70 for the accelerator adjustments.

http://test.steelsoldiers.com/upload/M35/TM9-2320-361-20.pdf

THANKS! That's what I wanted