The depot I work at has a pile (36 tires!!) of brand new 335/80r20. All but a few are on military rims, it's a 10 bolt pattern. The QRP manager says they will prob go in the next sell off. Can these be put on m35a2 stock rims IF tubes are used to avoid the sealing issues? If not would the 20 bolts, nuts, washers already on the tires be correct to use when putting on a 6 to 10 bolt adapter plate? Goal would be to steal extra hardware from extra tires and avoid that part of the cost in adapter plates. Also I've trolled lots of posts and searched Google for cheapest adapter plates and best I can find is 150$ a piece, does anyone know of anything cheaper? I want to single out, flip hubs and use these 335s, as cheap as possible without doing anything UNSAFE. That's why I am seeking knowledge from all the great people on this forum. -- I hope to buy the whole lot and will be happy to sell most of them at a really good price, but will have to see if I even end up with them. Not worried about getting rich, not sure what I'll be out for the tires either, but would love to walk away even and with the 335s on my truck. All but 2 have time and they are not dry rotting at all, still have little nubbies on all but a few of them. There are also 4 445s on 20 inch 10 bolts rims, not the same as the mrap tires, brand new, not sure what I could do with them unless someone has 2 more or a bobbed duece. Anyway, love to have some feed back, sorry for being long winded.