winter has ended, putting battereies back in five ton.

[Jericho]

thanks in advance brain dead hooking batteries back in my M931A2 I run a two 1000 cca group 31 set negative to battery one, , NEG post , POS lead on battery one to NEG post on battery two . POS post on battery two to ( positive) load SLAVE CABLE neg to ground BUT Positive lead to battery two pos post OR pos lead from slave receptical to negative post on battery two just to tired to even think about it And I do electrical all the time bit of ally hiemers

 

[74M35A2]

Ughhhhhh, how about a bar napkin drawing?

 

[Jericho]

Ughhhhhh, how about a bar napkin drawing?

Thanks for your replies. Was a long day. Slept on it fixed in twenty min this morning. Battery one to battery two. Pos to neg lead was bad. Ohms good. Continuity checked good. Wouldn’t allow current to pass. Made a new lead. Viola fixed. Dam confusing when all the normal checks say “ I am Good” and it isn’t finally slaved in a new cable. Worked. Fired right up. All good now. Thanks again guys and gals