XM708 refurb

[JimC2]

The dump bed is compatible with a 6" wood height extension. I'm thinking two red oak 2x8s 6 feet long cut to 6" width.
Any thoughts?

 

[JimC2]

Dumb question - how do the sideboards mount?
It isn't obvious looking at the truck.

 

[G744]

Looks to me you have side risers with channels to accommodate the boards.

If not, maybe there are reinforcements in the bed sides that would accept stakes that could be fastened to the boards.

G744

 

[JimC2]

"Looks to me you have side risers with channels to accommodate the boards".

I don't. The side risers don't have channels.
I'm going to spot weld 4 six inch long 1.625x1.625x1.625 steel U-channels vertically at the front and rear corners of the risers to receive 6 foot long red oak 2x8s ripped to 6 inches as drop in sideboards.

 

[G744]

Sounds like a good plan.

 

[m1010plowboy]

Found another picture and it looks like the board is on the inside of the back post. There is not a lot of info out there but somebody somewhere would have put a TM together so they could later bark, 'Why didn't you read the TM"? If I come across more details I'll get them up here. This is a cool picture with Frank mentioning """" note from the Patton museum indicates XM708 only one of the series to have power brakes """

Looks like you might have power brakes!

https://www.steelsoldiers.com/threads/small-dump-truck-vietnam-era.164076/#post-1969659

Started peeling through the TM's over here but haven't found details yet. XM708 is not mentioned in the operators manual. There must be one out there.

TM's for the M37

Listed below are a number of the TM's for the M37 series trucks. To save them to your computer, right click, select "save as". TM 9-2320-212-20 TM 9-1840A (TO 19-75B-15) TM 9-2520-232-35 TB 9-2855-45 (TO 36Y17-5-1-7) TM 9-8031-2 M37 Power Train-Body-Frame.pdf TM...

www.steelsoldiers.com

 

[JimC2]

"Looks like you might have power brakes!"
Yeah, I noticed that back in 1972 when I got this truck. Brakes aren't great, but they are better than my 37.