PLS info/measurements.

[hot rod deuce]

Hey guys,

I'm wondering if any one has access to a PLS, It needs to be the 1075 type with 5 axles,10 wheels. I'm looking for some measurments of the axles.

I can bribe you with tank driving and machine gun shooting if you swing by.

Thanks
-Tony

 

[gringeltaube]

Hey, glad to see you again...!

I don't have a M1075 near by but I can answer your last Q: Same as HET; 10 on 13.2"



G.

 

[bikeman]

Axles on all HEMMT series trucks (true HEMMTs) are the same. What's your overall question? the axles or the entire truck measurements (IE shipping?)

 

[paradeduty]

Sorry Bikeman, I have HEMTTs, LVS, PLS and HET - the only ones with the same rims are the PLS and the HET. I think the HET has a different hub planetary gear set-up than the PLS (to handle the much greater GCVWR and ending up with a 45 MPH maximum and a 8 1/2 foot width). That means that all four of the mentioned HEMTT "variants" use different axle assemblies.

 

[hot rod deuce]

paradeduty, Yes, You are right. I send you a PM in regards to the project.

 

[bikeman]

Sorry Bikeman, I have HEMTTs, LVS, PLS and HET - the only ones with the same rims are the PLS and the HET. I think the HET has a different hub planetary gear set-up than the PLS (to handle the much greater GCVWR and ending up with a 45 MPH maximum and a 8 1/2 foot width). That means that all four of the mentioned HEMTT "variants" use different axle assemblies.

Well crap, I never had to go into the axles, just replacement tires/rims, guess I didn't look close enough. I know the A4 PLS we were fielded had a different setup but that's all I recall, guess I should have paid closer attention. Thanks!