- 3,215
- 3,234
- 113
- Location
- NORTH (Canada)
Rebuilt LDS is almost done; just putting the flywheel and clutch on. I don"t think I am brave enough to just put the engine into the truck and keep my fingers crossed that she will run and run right. I'd like to try her out before I go through the pain of lifting everthyng in.
My plan is to have the engine on a pallet, supported by blocks at the mounting points and the bell housing and strapped to the pallet with two cargo straps so she cannot wander or fall over.
I would hook up a main fuel line and a return line to a jerry can. Perhaps have the jerry can elevated for ease of pumping for the IP?
2x12V batteries and a set of jumper cables to turn the starter.
Piece of 2x6 handy in case of runaway.
Anything else I should do?
My plan is to have the engine on a pallet, supported by blocks at the mounting points and the bell housing and strapped to the pallet with two cargo straps so she cannot wander or fall over.
I would hook up a main fuel line and a return line to a jerry can. Perhaps have the jerry can elevated for ease of pumping for the IP?
2x12V batteries and a set of jumper cables to turn the starter.
Piece of 2x6 handy in case of runaway.
Anything else I should do?