Augdog1964
Member
- 522
- 15
- 18
- Location
- Richmond, IN
Has anyone ever seen a turret / weapon's station, installed in a helmet hardtop?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Turret / Weapon's Station in Helmet Top
- Thread starter Augdog1964
- Start date
tomelroy
Active member
- 184
- 68
- 28
- Location
- Morgan, UT
yes
- 4,400
- 4,181
- 113
- Location
- Brentwood, Calif
Yep....
Augdog1964
Member
- 522
- 15
- 18
- Location
- Richmond, IN
Thanks guys! Now to find out how it was installed!
Action
Well-known member
- 3,576
- 1,557
- 113
- Location
- East Tennessee
With nuts and bolts.
Augdog1964
Member
- 522
- 15
- 18
- Location
- Richmond, IN
Was that mean't to be helpful, or sarcastic?
If helpful, does that mean the ring simply mounts via bolts on either side of the hardtop?
I don't know if it can support the weight on its own. The SF GMV uses an independent support structure shown really well here:
http://g503.com/forums/viewtopic.php?f=63&t=210224&p=1231822&hilit=soft+top+turret#p1231822
http://g503.com/forums/viewtopic.php?f=63&t=210224&p=1231822&hilit=soft+top+turret#p1231822
Augdog1964
Member
- 522
- 15
- 18
- Location
- Richmond, IN
That is what I need... where can one of those kits be located?
dilvoy
Active member
- 733
- 25
- 28
- Location
- San Francisco, Ca.
That is the standard Old School Turret Support setup that was used on Weapons Carriers ect. That is not nearly high enough to be able to be used for the Helmet Tops. It is normally up tight against the bottom of the roof panel. The Helmet tops are about six or more inches higher than an Old School Slant Back roof panel so you would have to make some sort of adaptor to extend up towards the Helmet top roof and then support the Turret Bearing. Just raising the Turret support up may be problematic as the forward legs will probably hit the front curved portion of the Helmet Top and you will have to make up new connectors up front, for the B Pillar connections and for the C Beam connections too.
These look like its the same turret as a Hmmwv would have on a hardtop except the coupla / shield
There are 900 series 5 tons that use a flat turret plate which accepts Hmmwv turret top parts.
There's also a ring adapter for an M1151 that can be used......but hard to find as is with all the other turret parts.
The 3 photo's in earlier post above seem to be using the REAL heavy M66 gun ring.