• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Turret / Weapon's Station in Helmet Top

D

dilvoy

Active member
733
25
28
Location
San Francisco, Ca.
Augdog1964 said:
Was that mean't to be helpful, or sarcastic?

If helpful, does that mean the ring simply mounts via bolts on either side of the hardtop?
Click to expand...
That is the standard Old School Turret Support setup that was used on Weapons Carriers ect. That is not nearly high enough to be able to be used for the Helmet Tops. It is normally up tight against the bottom of the roof panel. The Helmet tops are about six or more inches higher than an Old School Slant Back roof panel so you would have to make some sort of adaptor to extend up towards the Helmet top roof and then support the Turret Bearing. Just raising the Turret support up may be problematic as the forward legs will probably hit the front curved portion of the Helmet Top and you will have to make up new connectors up front, for the B Pillar connections and for the C Beam connections too.
 
86humv

86humv

Well-known member
Steel Soldiers Supporter
1,693
493
83
Location
Texas
helmettop1.jpg
These look like its the same turret as a Hmmwv would have on a hardtop except the coupla / shield
There are 900 series 5 tons that use a flat turret plate which accepts Hmmwv turret top parts.
There's also a ring adapter for an M1151 that can be used......but hard to find as is with all the other turret parts.
The 3 photo's in earlier post above seem to be using the REAL heavy M66 gun ring.
 
You must log in or register to reply here.
109,383members
164,342threads
2,312,895posts
577online users
Top