M920 Vin location on the Frame?

[Hammer]

OK, I have two M920 trucks that I cannot find the VIN location on the frame.
I obviously see it on the driver side door's data plates, but no where on the frame.
One was rebuilt in 1997, the other in 2008.

 

[Hammer]

As usual, no help here on this site.
I KNOW where I read one post that said it's about the same as M939 trucks (Simp mentioned this.)
I went out and sanded off the paint in a large patch of the frame in that area, and no luck.

Anyone have a picture of where their VIN was on their 915/916/920?

 

[Hammer]

As usual, no help here on this site.
I KNOW where I read one post that said it's about the same as M939 trucks (Simp mentioned this.)
I went out and sanded off the paint in a large patch of the frame in that area, and no luck.

Anyone have a picture of where their VIN was on their 915/916/920?

 

[Coffey1]

Mine was right at steering gear box.

 

[Hammer]

Mine was right at steering gear box.

In about the couple inches I didn't take the paint off?
I wasn't too keen to take the paint off that close to the mount and get rust under it.

 

[Hammer]

Btw, does anyone have a picture of their data plate that shows a manufacture date of their 920 with a VIN number ending in a number larger than 10371?
When they rebuilt the truck, they completely removed the original data plate and put a new plate that only says it was remanufactured 5/8, and the truck was registered as a 2008 truck.
I obviously don't want a 2008 truck, I want to register it as a 1980 truck that it should be.