-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Generator MEP 803A problem “over voltage”
- Thread starter Captcday
- Start date
- 3,829
- 5,946
- 113
- Location
- MA
Can you be more specific on details, like under what conditions it happens.. right after startup? After running a while? Have you performed any testing on items in the set related to this, or referenced the tech manual?
At first it quit right after start up. We cycled the 1/3 phase switch a dozen times or so and it did start. We had it on a load bank at 7kw single phase and it ran for about 5 minutes. Then it quit again. Throwing the Over Voltage again.Do not know what to test. Also do not have a tech manual .
Ray70
Well-known member
- 2,595
- 5,912
- 113
- Location
- West greenwich/RI
I'd start by cleaning and exercising both the AC select switch and the AM/VM switch. Many times it's just a dirty connection inside one of the switches. If that doesn't help we will have to dig deeper.
- 16,768
- 24,094
- 113
- Location
- Burgkunstadt, Germany
You can download the TM's here in the forum.
I would also start by doing the above.
- 2,145
- 3,526
- 113
- Location
- Pepperell, Massachusetts
You might want to look at this thread --> Overvoltage
Some info on what to check when chasing an overvoltage fault.
Some info on what to check when chasing an overvoltage fault.
Thank you very much . I’ll do that and post what happens.
Howdy,
Start here in this thread. The 2nd post has quick links to lots of stuff. The third post has links to the manuals.
MEP-802A MEP-803A Filters and Parts
Howdy, MEP-802a and MEP-803a use all the same filters and such MEP-802A ONAN DN2M 2-cylinder engine (Lister-Petter LPW2) Liquid cooled diesel, aluminum housing MEP-803A ONAN DN4M 4-cylinder engine (Lister-Petter LPW4) Liquid cooled diesel, aluminum housing Oil Filter Spin-On (FILTER ELEMENT...
www.steelsoldiers.com
- 3,829
- 5,946
- 113
- Location
- MA
Yeah get the TMs first and foremost.
TM ending in -10 is an operators manual
TM ending in -24 is the troubleshooting manual
TM ending in -24P is exploded parts diagrams of everything that makes that machine up.
For troubleshooting purposes, almost EVERYTHING you could ever encounter, is covered by the -24. I think you have a corrosion issue, and I think you need to plan on purchasing a good contact cleaner, and taking the roof off the machine to get to the fun stuff.
TM ending in -10 is an operators manual
TM ending in -24 is the troubleshooting manual
TM ending in -24P is exploded parts diagrams of everything that makes that machine up.
For troubleshooting purposes, almost EVERYTHING you could ever encounter, is covered by the -24. I think you have a corrosion issue, and I think you need to plan on purchasing a good contact cleaner, and taking the roof off the machine to get to the fun stuff.