No power!

[Antonio Pena]

MEP804B Generator has no power output, I’ve done a few voltage tests recommended by your forums a few months ago and had to stop. I want to start working on it again any help would be greatly appreciated
Thank You

 

[DieselAddict]

Can you post a recap of what you've done so far?

Do you have the TMs and have you reviewed the troublshooting in the TM?

 

[Antonio Pena]

Can you post a recap of what you've done so far?

Do you have the TMs and have you reviewed the troublshooting in the TM?

It’s been over three months ago I’m having problems looking up what I did, I do have the TMs all I can say is That I has checking the CR’s at start up I guess that’s where I need to start

 

[DieselAddict]

I assume you've tried holding the switch in the START position after the engine starts? Do you get any voltage while you are in START?

 

[Antonio Pena]

I assume you've tried holding the switch in the START position after the engine starts? Do you get any voltage while you are in START?

No voltage

 

[DieselAddict]

Sounds like you need to start at the beginning and do some testing. Start with the MPU and speed controller. If that isn't working you'll not flash the field to make power.

 

[Antonio Pena]

MPU and speed controls seem to be working

 

[Antonio Pena]

MPU and speed controls seem to be working

What I don’t have is the flash field circuit

 

[DieselAddict]

I think more detail about what you've done to test everything would be helpful at this point.

 

[Antonio Pena]

I think more detail about what you've done to test everything would be helpful at this point.

 

[Antonio Pena]

I don’t know how to attach previous files, This is one of the suggested tests