-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Help with Rough Country 4 inch lift
- Thread starter scottodog
- Start date
scottc
Member
- 127
- 3
- 18
- Location
- Sebring, Florida
Problems with the front or rear?
pigfoot63
Member
- 170
- 0
- 16
- Location
- Gainesville, Ga.
Just about any driveline shop can mke them for you, carry your old one and tell'em how much longer you need.
Cucvnut
Well-known member
- 3,804
- 61
- 48
- Location
- Carver, Oregon
did you tell the company you got your lift from you had a K30 ? also do a u bolt flip in the back so the rear u bolts have the nut on top of the axle instead of under it so they wont get caught on anything you just need u bolts plates from DIY4x4
LTWVARNG
Member
- 191
- 2
- 18
My lift is from rough country to. The dont make U Bolts for the Dana 60's you will have to get them from superlift. They told me that when I bought it from them...fortunately I have a Blazer, so what came with my kit was good to go. I still have not had a chance to put it on though.
dstang97
Well-known member
- 1,859
- 30
- 48
- Location
- Clover, SC
I made mine fit.
Croatan_Kid
Member
- 691
- 2
- 18
- Location
- New Bern, NC
I think the last set I bought came from SuperLift.
If you do a u-bolt flip, you'll need to have a spring lift. If not, the spring plate will hit the side of the bumpstop mount when you flex. That's why they put them on upside down from the factory. The top of the spring is closer to the bottom of the frame than on a 1/2 or 3/4 ton.
Offroad Design U-Bolt Ubolt Reversal Kits GM Chevy Blazer Jimmy Pickup
If you do a u-bolt flip, you'll need to have a spring lift. If not, the spring plate will hit the side of the bumpstop mount when you flex. That's why they put them on upside down from the factory. The top of the spring is closer to the bottom of the frame than on a 1/2 or 3/4 ton.
Offroad Design U-Bolt Ubolt Reversal Kits GM Chevy Blazer Jimmy Pickup
Cucvnut
Well-known member
- 3,804
- 61
- 48
- Location
- Carver, Oregon
thats what i was talking about 
scottc
Member
- 127
- 3
- 18
- Location
- Sebring, Florida
Send dimensions you need I think I have some that you are more than welcome to if you are willing to cover shipping.
AJMBLAZER
New member
- 2,688
- 8
- 0
- Location
- Paducah, KY
Try your local parts stores and see if they have what you need. NAPA has scads of applications but for the Dana 60 you're probably SOL. I ended up having a local parts store make me a set of U-bolts. The two studs on the passenger side I just replaced with longer Grade 8 bolts. Worked fine.