Recent content by Antonio Pena

  1. A

    Electronic governor control for MEP 804B

    I'm screwed up! I bought WRONG A1 I should have have got the TRC A1 attached is T1 & voltage adjustment control, I did not find S12 to find resistor. Should I buy TRC A1?
  2. A

    Electronic governor control for MEP 804B

    Thank you so much. I’ll check it and keep you posted, I did not know that 804B & 804A used either TRC or Libby Thanks again for the information
  3. A

    Electronic governor control for MEP 804B

    I have a Libby A1. How do verify correct T1, R16, and S12? Gen set MEP 804 B I'm assuming 804B uses a Libby and the 804A uses a TRC is this correct? My apologies for my illiteracy in previous threads I get to wound up and frustrated and using my cell phone doesn't help I would appreciate any...
  4. A

    MEP804b voltage regulator

    I’m back to square one, I used a Libby VR for MEP804B can anybody help me troubleshoot the voltage regulator?
  5. A

    Electronic governor control for MEP 804B

    How do I verify?
  6. A

    Electronic governor control for MEP 804B

    It’s in the response to post number two that’s the part number I shouldn’t have to change anything I don’t know!
  7. A

    Electronic governor control for MEP 804B

    The response to thread 2
  8. A

    Electronic governor control for MEP 804B

    It was post 1&2 I unable to forward I don’t know if you can see it?
  9. A

    Electronic governor control for MEP 804B

    I went with thru this subject when I ordered it let me see if I can find it thanks
  10. A

    Electronic governor control for MEP 804B

    I’m trying to find a previous post that gave me a EBAY part number it’s in one of my posts
  11. A

    Electronic governor control for MEP 804B

    Libby, I bought it on EBAY open box
  12. A

    Electronic governor control for MEP 804B

    I did not check for power before the relay swap, when I release S-1 I lose power and the hertz meter drops off.
  13. A

    Electronic governor control for MEP 804B

    I swapped out relays K-15 with K-14 same problem persiste although when I hold S-1 in the start position I do get 120 volt to the convinces outlet
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks