Recent content by DUECE-COUPE

I’m looking for some of the bases used for the command tent. I have knuckles I can trade. I have a complete frame and tent. No fly yet. I think I can reassemble the frame I have if I can get the feet. Any help would do. I can pay for both trips.

I have a couple drag links. Try marvel mystery oil in the supply port and keep working the wheel left and right to cycle the valve

I have replaced my brake booster and I have air leaking out of the slobber tube when I have air pressure. I’ve swapped out brake boosters twice with the same result.

Where can you get the rings to rebuild them. I have 2 that I would like to rebuild for resale.

Field fix. Disconnect the two lines by the coolant tank, and put a sick the same diameter as the heater core on them and use the same clamps you loosened to secure it. You are just trying to block of the heater core, you don’t have to loop it back to the block, just closing the system. I did...

I am looking for a CBC for an M-101A2. Any leads???

I am thinking of getting an M275A2. Does the M-275A2 have posi/Limited Slip Differential axles in the rear??? Since it is a Tractor, I was thinking that it might be required to move heavy loads. Please advise.

The ladder you are looking at is a ladder for the M373 type trailer. there is a set of holes on the side of the trailer under the door. the round metal attachment is inserted into this hole, and the lever turned to rotate a cam that locks the ladder to the trailer. They are hard to find, and...

Any idea's on how i can do this???

Don't forget to mount a spare tire on the spare tire rack on the truck. I put it there for a reason!!!!

Sir, You have in fact a WC-53. The WC-54 was the Ambulance version the family of vehicles.

Not yet!!!!

I want to see what you did with "my supply truck"

The fender on the trailer bed is very close to the inside dual. Run a 4x4 PT between the bed and the frame, and drill 3/4 in hole to allow the frame rivets to sink into the wood.

I nominate my Bobbed Deuce