-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Recent content by GTUnit
-
G
Rebuilding X doors - Parts
Why would tempered glass be thinner? Just order the thickness you need. That is what I am about to do. https://www.onedayglass.com/ -
G
REV Injector Nozzle Replacement without Removing the 400A Alternator?
Did you try a box wrench? -
G
Hydro-boost / hose o-ring help
If anyone needs to find this O Ring in the future here is the info: NSN: 5331-00-580-6586 Specs Attached A close substitute is a standard Buna N o-ring with 5/15 ID, 7/16 OD, and 1/16 section width McMaster Carr pt # 9452K19 or similar. -
G
So I was bored and built a turbo kit
How did you adjust for additional fuel under boost?- GTUnit
- Post #24
- Forum: HMMWV Hot Rodding and Modification & Civilian H1
-
G
water in engine
In a HMMWV turbo motor, if you leave the turbo intake tube off, close the hood, and it rains, water will drain directly into the turbo intake and compressor side. Water does not make it past the turbo compressor side into the engine. Your engine is fine. Water does not make it past the turbo... -
G
M1167 Turret delete plate questions.
I sell 11xx series turret cover plates. 1/4" 6061-T6 CNC cut. Guaranteed perfect fit and bolt hole alignment. Asking 500. I have sold a few on ebay and locally. New message from: mearicleauction (43) Just placed the cover on the Humvee, excellent fit, excellent product. Just for info the... -
G
MSD-ICE Kit Diagnostics
Does anyone have the PC software they can share? I just got myself a kit but no disks. -
G
6.5 Turbo Fuel System Diagnostics
Dont remove the pump until you test it again. Hook up a piece of hose to the lift pump inlet and tan that into a gas can or small container with foretell in it, Run a clear hose from the pump outlet back into your container. Have someone crank the motor and observe. If the pump is 10 years old... -
G
GM-7 Turbocharger
Any feedback on how you guys like the wheels?- GTUnit
- Post #8
- Forum: HMMWV Hot Rodding and Modification & Civilian H1
-
G
New owner of a M 1084
Does anyone know how to test a 4 way spool valve for bypass leakage or being worn out? Shrieking noises from one 4 way control valve when PTO is on. -
G
Injection pump screen
I like spraying some phosphoric acid based Rust Remover at rusty parts that need to come apart. It dissolves a decent amount of the rust holding the parts together. -
G
Does anyone know where I can find the tailgate strap panel
Actually the panel I have is not the one OP posted. Its the one in these photos. From a M1167.Anyone know what this variation is for? The panel is curved and wraps around the cargo hatch when flipped up.