Recent content by sellbooze

I would love to do that , but I keep it out front of my business to attract attention.

I have a canvas cover on the cab of my M35a2. It was brand new when I purchased and would like to keep it nice the best I can in this brutal Central Florida Sun. Any tips on products that might make it last longer. And yes I understand keeping out of the sun would be the first item on the list...

Gulfway

@ Maverick BAWHAHAHAHAHAH !!!! rofl

This is a great success story ! What a war story !! Congrats on the new truck.

Looks as if there was a # 8 with a broken circle around it painted on my passenger door at one time. Any clue what this would have meant ?

Thanks guys ! I has a good time doing this thread. Next week I hope to do one on the replacement of parking brake springs and cable. Doing my research this weekend and will attempt the work this week.

Take plug that was on old switch and cut it off. The new plug goes on as follows. Put rubber boot over wire , then the plastic sleeve. Strip wire and crimp on new connector. Pull boot and sleeve over connector and plug in to new switch. I am sorry I did not take pics of the assembly of the...

My Deuce brake light switch stopped working and needed replacement. I bought a replacement kit from Erics Military supply for about $60. The kit came with the wrong size compression elbow for my truck. Kit comes with a 1/2 and I needed the 3/8. NAPA did not have this so I went down to Amazon...

I really enjoied reading about your recovery ! Congrats on the new truck .

Swapped my D turbo for a brand spanking new C turbo ! A lot of work but well worth the noise !!

All turned out GREAT !!! I took my grinder , replaced the hard wheel with a flap sand wheel , and slowly took it it down to a nice flat finish. I used a brand new gasket on the exhaust and oil supply. Looks good ! Ran for a while, No leaks as of yet. Got dark on me , so I will run again...

In the removal of my turbo , I broke the rear threaded studs off in the exhaust manifold. This morning I took my blue tip wrench out and while heating up the manifold I melted a small spot.... :shock: What to do ? carefully grind down ?

@ gimpierob , naw really dont want to sell it just wondered what they are for. It came from DREMO this way. @ NK thanks for the pic . NOw I see what its for.

Broke the studs while removing my turbo. I have seen a few threads about this and people breaking off the ears on the exhaust manifold while heating it with blue tip wrench. I thought about taking off the E manifold to drill it out but am afraid to break studs/bolts in the block. I have tried...