Recent content by sfus2645

Ill look into the fuel solenoid tomorrow. Thank you

I removed the power to the fuel pump

Hi Poccur I finally got the generator working. I installed an Automatic Transfer Switch to power the shop, and ran into a new problem. The generator can be starter by the ATS, but once it starts it wont shut down, I removed the power to the batteries, removed the power to the pump, and it only...

Thank you very much I will try the test tomorrow.

I installed the new VR but it doesn't work either. Maybe is something else.

I did the test specified on the TM on H instead of 8 VDC I got 10-11 VDC on J instead of 67.5 to 90 VAC I got 1.5 VAC on L instead of 108 to 132 VAc I got 11 to 12 VAC

Both the light and very low voltage

You are right it's a MEP-806A

I installed the new pump, it starts perfect. Now I have a new problem, under voltage. I replaced the fuse next to the voltage regulator just in case but it didn't solve the problem. Any Ideas

I finally was abled to pull it out.

Thank you, I'm going to work on it, I just received a new voltage regulator

I heated it up till it was red hot, applied the air hammer and it came off. Thank you very much for the help

Hello, I have a 1995 MEP006A with a John Deere engine. I need to rebuild the fuel injection pump. I have try everything I can think off to remove that pump, I even built a tool with a 2 ton hydraulic bottle jack, and applied at least two tons of pressure on it, and it doesn't move. Any ideas??

I ordered a new voltage regulator and still have the same problem. Any other suggestions?

Any idea how to repair or replace the voltage regulator on this unit.?