Recent content by sgarfa

thanks a lot..what servo and plc you use?....at this point is better to buy directly the plc instead of esd5500 + plc (in the future)

Goodmorning, I would be interested to electronically adjusting the rpms of my 004 to stabilize the 50hz, considering that even by adjusting the knurled screw I did not get quick responses to the load variations, I would have thought of the Chinese kits ADC100 + SD550OE...and anyway is the first...

this is the total answer ... thanks in any case, the generator has been there for a few years ... but only now I have begun to use it

@1800 diesel, what you say is absolutely right, only that I premise that i weld the tank and I took the opportunity to overhaul the whole fuel supply .. now the possibility of air in the circuit is possible .. I will check again..

ehm...Regarding the pump I had disassembled it just to solve an annoying loss of fuel that came from the knurled knob...but before the generator gave these symptoms, I would also revise the pump but I would not do it for nothing .. considering that i willi certainly have trouble finding the...

in short yes, the engine whit out load tends to accelerate a little, I mounted a new panel instrument between a phase and L0 ... to monitor voltage frequency and working hours ... in any case the increase of hz is noticed both by the new instrument, and also old one ... I honestly do not think...

I noticed the problem about the trend of increasing of Hz (And rpm) specially with no load... from 50 to 52hz (i'm in italy) in 2/3 minutes... at the same time if I apply sudden loads of 60/80%, like a welding machine I notice an inadequate tendency not to recover rpm...and the consequent drop...

the last question for now:roll:....I read the manual, at the pump arrive 2 cables, the p55x and p80n respectively the ground and 24v, now as it does the solenoid to manage the metering valve?, the sensitive info arrives to another system inside the pump?

mhh I watched this... https://www.youtube.com/watch?v=I_ykrzMbTZk then I think it's me i don't know to use the generator, i'm accustomed to modern generators, where it dosn't anything to touch.....in the video when the gen set is frequency goes to full scale ...but once loaded stabilizes at...

thanks a lot for taking into consideration my question.. here in europe we use the 50hz frequency, and at this frequency the generator delivers significantly less kw, anyway the welder is 10/12kw at maximum,and when the balance drops dangerously frequency to 40 Hz,When welding, the frequency...

hello to all!, more then a problem, i ask for a question, in short when I apply a load (a welder) even if they are only 70\60% percent rated current , the frequency on the meter falls, it is normal?, because the welder does not reduce the power, now I wonder if something is wrong in the...

thank you so much of the answer, but I usually keep te start switch up for few seconds until the frequency meter starts to measure, but now when i release the switch to run position the meters go to 0, tomorrow i try to put the start switch up for more seconds... thank you so much

Good afternoon everyone, after a rebuild of the injection pump (for which I have also removed the alternator)...at the restarting, the voltmeter and the frequency meter are switched off when i release the starter motor and put the switch in run position, if i put back the switch in start...

Hi, i'm amedeo from italy for now I possess only a almost running mep004aaua....my dream is tu buy someday a M746 i love the 12v71!! congratulations for the forum and thanks to all

Now the gen set works perfectly...but i' no control no idea of fuel, lub pressure, voltage, %use ..ecc..