Search results

Old school seal remover, I still use one.

Thanks OD and AA. But that would help with sagging, which it isn't doing. Only weakness I see is twisting, like if your foot got in the way while opening or closing. So far so good.

Thanks AA. Screen door is actually steel. Torsional strength of the door is a bit lacking, otherwise works well.

Well now I officially have an installed screen door. I'm sure not many deuces have one. I was not sure what I wanted to do, either get one custom made, make one out of wood, cut down a conventional screen door, or cut down a sliding door screen panel. The latter won out. Took it apart...

Looking for the deuce half trailer connector complete, rain cover, socket, terminals and at least six inches of cable out of the back.

Count me in!

Had a lot of other things to do this weekend as well as some less than perfect weather, so only a couple of things got done. Finished my swing up ladder "latch". Wasn't sure how I was going to secure it, but turned out to be a simple deal. Two large eyebolts and a padlock. Good solid mount...

Never say never!

Treat it like an acid, which it basically is. No skin contact, breathing of spray or vapors, no eye contact. And don't spill on anything, including concrete. Good stuff, but respect it.

Sounds like a relocation should be in your plans!

Thanks AA. It's finally starting to come together. Need it at least 80% done for the upcoming Winter Rally here though!

Yes it is. I already see how much of an improvement it will be.

No, is a common RV one. Had it by the door previously.

Made good progress the last three days. Had some aluminum expanded metal custom cut by the metal shop. Got that painted and installed on the exterior for screen protection. Also had some cut for shelving, yet to be installed. Got most of the screens installed as well. Still need to screen...

Then I made a single pivot point to tie in to the rear of the box. Wanted it to be able to pivot a bit if needed. I figured with the springs I used in the frame mounts, that I should allow for some movement. Cut the vent hole for the hot water heater and installed the heater for good...

Not much to show for 10 days in a row, but did get some stuff done. Was able to find two more corner bows courtesy of FloridaAKM ( thanks !) and finish fabbing up the roof supports. Got that finalized and tied in, started on the roof sheet metal install. Used the panels I had removed from the...

Got rained out today, so didn't get as much done. Did set up another bow frame and cross bar, still a lot to do. Also still tinkering with my trailer light set up, had a bad converter box, swapped that out, now it gives me brake lights for awhile after everything is turned off. The saga...

Feel like I got a decent amount done today even with half a day to do it. Ospho'ed the roof panels for the deck, then got them primed. Got the deck side plates cut and installed. Started on the roof framing, got two bow corners mocked up with some aluminum square tubing. Put that up across...