Search results

You are describing an M1151/52/65/67 frame, which have no vents. They use a plastic external plenum to deliver air to the glass. You need and M1025/26/44/45 frame which is identical to the soft top frame except for corner mounts and snubbed holes. You can buy the mounts and plug the snubbed...

In a pinch a coupling nut with locktight will work without dropping the starter.

Nice Score! Easy restore and valuable!

It had to come out Augi, for the TH400 had to be pulled (the pump failed), so why not pull the body! I had a complete power plant ready to go so it was quick, correct and easy!

This is what happened to it! http://www.steelsoldiers.com/showthread.php?115558-HMMWV-eye-candy-again!&p=1451356&highlight=#post1451356 I then sold it and it was sold again to another guy that put a slant back kit on it and sold it... The 6BT is now in an H1 in Texas with a 47RH Transmission...

#24 is the Pawl (IIRC) and it is required and they do wear out, Used in the 218 and 242 and the electric speedo setup. #1 is readily available and should not be $123. I may have a spare. Ill pm you tonight if I do. Check 17 and 2. 2 will break sooner or later. 17 can be installed poorly...

Did you open the commanders door and look at the placard on the b pillar sail panel? Should say on the top right corner what it was. M1025/26 and has mounts for MK64 iirc. A0 truck.

Sorry, I'm not making them.

Which light bar? Ibistek 45/66/78/360, after market? I made brackets for the 66 and 78 for hmmwv. still have some of each.

With good front springs then I would think that a 1" lift is okay, else 2". Do the same for the hood too. FYI, once you approach 2" or greater, you may run into a few things: Steering column shaft to steering gear will rub on the lower end of the opening through the fire wall, Shifting linkage...

Here is an H-Turret SF setup. Fun when it is not raining out.

Yes!

Once you isolate the gen and starter (one at a time) and you still have the draw, then check wires and bulk head fitting for 24vdc positive stud. An assumption is being made that you do not have a 4L80e and TCM.

I weld a bolt to it and turn it out. Steve's way works great also, I just like welding!

Loose connection somewhere. Disconnect batteries when checking connections or you may be buying an new box.

H2 rims will fit but the offset may set them out a little. A stock M998 with fresh springs should be able to house a 38" tire, you will need to adjust full lock. If front end is sagging, then that needs to be addressed before any other mods or lift the tub.

I see you installed new batteries. Make sure they are fully charged and good connections (as Steve says). Low voltage will cause this and may cause your control box to crap out.

I had a hmmwv that this was done to. It worked fine as long as you were not overheating the glow plugs buy keeping the lit up too long.

The divider is also used as a load wall for the seat base and the commander's arse.

Steve, you are missing the insulation rod clip on the commanders side. Are you slipping...lol