Search results

I sold my 3 FMTVs because they were taking too much of my time. My M932a2 in comparison is a fraction of the headaches. Both have pros and cons just didn't like the pros enough to justify the time.

Should be this. I had a 2511 code in my M1083a0 and needed a transmission rebuild from a blown pump. 29505601 https://www.allisontransmissionpart.com/allison_parts/56/01/29505601.html

The spreadsheet is designed for on the road quick repairs. Body parts will need to be ordered through ATAP in Alabama.

Using heat from a blow torch and penetrating oil and putting the whole casing in a vice horizontally I have yet to break one.

Pretty sure @swiss put a 6.5 na injection pump from a humvee onto his old m1009.

Need to test actual fuel rail/ line pressure to see if it meets the proper pressure spec for the engine that is in the vehicle. If the pressure is too low then a pickup tube could be clogged or a line or the injection pump be bad. Also it could cause the injectors to not fire properly on some...

😭

If you had a version of the mk23 mtvr tm converted into a Dist. A for public release taking out any sensitive info the community would praise you!

If you run eco hubs then you will get more gear ratios.

Are you running rear steering assist to help with increased frame and wheelbase length? Sent from my iPhone using Tapatalk

I didn’t know I could be attracted to a truck

Have they updated the item’s to iAds files yet or are they all only on next gen viewer?

Good luck finding the TM online for an armored vehicle unless it is in Warthunder :ROFLMAO:

It is an oshkosh 30000 transfer case. Seals are probably going to be expensive. This might be it not sure dont quote me on it. The brother to the 30000 is the 55000 used in the hemtt and m1070 HET. The fender is going to likely be impossible to find unless you find someone with a parts truck or...

Here in a month or so I should have a parts truck I can pull from.

You are basically screwed unless as Mullaney said you are able to convince the government to give you them. They are classified and likely won’t ever be released in the next 22 years while they stay in active service.

No they seal when you inflate. Pics are appreciated Sent from my iPhone using Tapatalk

There are some valves by the frame rail should be one per axle called the qr1 valve that all the air dumps through

the ph616-6 is the same size generally as the smaller units. I have a tractor and had to move the air dryer and notch the center frame support just a hair but other than that it is the largest hoist you can reasonably fit

It is actually super nice to let you know if you have a tire leaking that you would otherwise not see or know. If you have 5 solid lights the controller is fried. Anything else the controller is salvageable and probably just a bad signal from the pressure transducer.