Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
Any more info on the kits and template? I have purchased the lights and plan to install them soon. a factory add on install sheet would be great if I could find one.
I already have the senior west coast mirrors, the lights will complete the look.
I run the Humvee take off 37s on my truck I have a four inch lift and cut fenders. I have a four inch block on the driver side steering knuckle with studs and have run like this for about four years. i broke the studs once and replaced them as well as the king pin bushings and springs. its not...
l believe the fords narrow up toward the front and the dimensions are off by a few inches in width full size truck bed means different things depending on ford/chevy/ dodge also what year. our trucks are square and wide I have had little to no luck finding a cap for mine
I used the forest green camo paint by rustoleum you can get from wally world .its held up well for the last 5 years . left the door panels alone as they were not too bad off but I did the dash with it.
I checked the computer at work and the resident grey beard in the shop, no left over parts from that long ago apparently but I found a set of bolt on at lmc
for this year model around 200 and shippin
generally I park and walk in since the kids taking orders can not hear over my exhaust anyhow. I love the field of vision to the rear, really hoping I won't back into anymore od green smart cars parked in front of the bushes at martins with my cargo cover up. :oops:
I was not lucky enough to get a set of the stock chevy mirrors. I had looked for a few years for a decent set with no luck, so I ended up going with some I found at mill supply.
well after a lot of time thinking about it and planning I finally got these mirrors on the truck. I used the stock mounting holes for the lower arm and cut to fit and rebent the upper arms does not look to bad imho. I think I got it pretty close to factory mounted configuration just no extra holes.
I used the mentioned site to buy tires for my truck, I had zero issues, fast service and have been running those same tires for the past three years. I do not remember ever seeing any posts about that vendor or his practices guess I just got lucky
any chance you could post a picture of what your set up looks like? mine was just a simple tie strap and flip open type deal so not sure where your problem might lie without seeing how your trucks setup. you could install a manual push button, I did eventually even after buying and installing a...
i bend wrenches pretty good but not so much on the chasing stray electrons thing. any tips from the more electrical savvy folks are appreciated. i have chased this issue for almost a year now. i drive the truck daily but knowing its not exactly working correct is annoying the heck out of me...
I have had a small issue for quite awhile now and I have been troubleshooting and searching out answers with the help of this forum to try and resolve it. I have not seen an issue quite like the one I seem to be having so I figure to finally post in hopes someone may be able to help.
Here's...
i did a search and downloaded the procedure and the 27si manual read all the posts i could find and all four i have done turned out perfectly before this truck i always had a shop do mine now that i have done it i will never pay someone to do that again.
pretty cold here today as well. to my surprise truck fired up and ran like it always does. I hold the manual plug button to a 10 count mash the accelerator to the floor, hold it and crank like the visor says. I run no additives except a quart of 10w30 on each fill up and a quart of tranny fluid...