Search results

Ill take it off and clean it after the snow melts and then the next snow storm ill see if that works. If it didn't ill look at the air drier.

Yea I normally do when I park it, every now and then I forget tho. I'm just trying to not needlessly crawl in the snow. But I guess if its frozen I can take the hairdryer to it

My m818 sprag has been working all year long but now that there snow and its cold it crapped out. Only noticed it when I needed it going up a hill the rear started hoping and sliding and nothing from the front. When I pulled in the driveway I Flores it and got the tires sping and then stopped...

It also broke a fuel tank strap somehow.... And put a small dent in the tank when it fell off

Lost me spare tire yesterday on a 20 minute drive on a logging road. Didn't notice it until I got home. Were the road ended and the gravel began it was really really washedout and bumpy so i went back out to look for it and it was gone already.... :( at least it was a really bad looking ndt and...

Picked up my nice new used Detroit locker for the m818, Thanks ryanaubra. Hopefully within the next 2 weeks I'll have it cleaned up and installed without removing the rear axle.

Dressage, my wife won about 10 ribbons they hand them out like candy on Halloween

Took the wife and critters to a horse show

Well i am lucky that the tail lights (stop and turn signals) are LED already. But this being a horse trailer i dont know what else the lights are connected to say the lights by the horses witch are not LED or lights in the kitchen or bathroom. So i figure id have fun and make one of these.

Does 8amps for service light and .5amps at 12v for each turn signal sound right?

Yea I was about ready to pull my hair out. But eventually after burning one resistor up I figured it out. The board is so easy to make, you came up with such a great idea!

I can but that would be to easy. I was kinda do this just to have a project for fun. I did figure out tho why i wasnt getting any voltage drop. The resistors will take in 24v and send out 24v if there is no load on them. That is why its important to check how many amp load is guna be on each...

So i tried to make the same boared as you for the lights on my horse trailer, well i got everything done went to check the voltage drop. Connected the board to the battery to with some jumpers. Then i took my volt meter and tested the other end of the resistors and it still came out at about 24...

Do you know where i can find this tool or what it is called? I cant seem to get the pins out without screwing them up or bending the tips.

Ok thank you that's what I figured but just wanted to be sure

Finally got my gooseneck hitch installed now for some wiring

How does one connect wires to the trailer connector? Do you just crimp it or solder it? BTW this is the back side of the male connector

In post 17 the picture is of the relief on my m818. Is that the same relief as on a 939 series truck or are there's bigger to clear the hero winch?

The truck isn't sitting on even ground, that might be why it looks like it's leaning

Is this the same relief that's on the 939 series trucks?