Search results

Took a minute to find the paint you used. Not genius but Genesis® Reduced Gloss (GF Series) http://www.sherwin-automotive.com/media/pds/English/5421.pdf Nice looking product. And it is helpfull for me to know that my backhoe will lift the body...

a sound that sounds like a hand crank winch being wound in. Chain drive transfer case, check the fluid level it takes auto trans fluid. Could be something with the chain also. But who knows. I have one that leaks bad and is usually low on fluid that is quite and i have one that looks great but...

I agree. And add that there does seem to be a high idle startup like the old carbed auto"s. Step on throttle to set high idle. Then crank it up, after awhile it settles down to normal idle.

Extreme over charge last time i saw that problem.

Your gen 1 light should be on very dim and get alittle brighter if you turn on the headlamps. Check voltage at the big main wire from each alt. You should show after startup around 14 volts at gen1 D side And 24 to 28 at gen2 P side. I am not sure the Alts are interchangable. I think there is...

X denotes experimental. So the Current version would be M381A2 ?

Ok now i have a question. They make two style's Long and short .. which is preferd?

I must be poor:oops: It does not get that cold here for the most part so a heater is not a have to have. We had on old tractor out front i pulled the fiter and base off of it and put it on the CUCV. Simular to this http://www.go2marine.com/product.do?no=84001F have not missed the stock junk. If...

Well; if you have the time and money throw a turbo charger on it. Or transplant a 6.5 turbo diesel into it. either way your problem will be gone. I remember way back when i lived in Denver. I wanted to go to the mountians. I had a 60's model Dodge van with a slant six in it. Made it to the foot...

Wonder where one of these is hiding? M8A1...

Exhaust fumes and children = ?

A compression test will do what you have done, locate a bad cylinder or cylinders. But does not do a very good job a diagnosing the problem. A leak down test on the bad cylinder will show you the problem. My 2 Cents = Do a leak down test on the problem cylinder...

I am impressed. Turned out very handsome. So you figured out how to put a ROPS on it yet?

RE: Re: My CUCV keeps blowing Starter Relay??? Been reading alot about ground cables lately. Maybe an intermitent ground problem? Good luck

Last long trip we took in the M-1009 we learned why they had all those roadside motels way back when. After a few hours at hwy speed with the windows down we were just covered in grime. 1/2 hour shower and still ruin the white motel towels. Had to stop and buy seat covers as the stock vinyl...

Used a tow dolly. Towed one with one from TX to Eastern TN. No trouble with the weight as long as there are no steep grades. (Had one hard pull over by chattanooga overheated going up and ran out of brakes going down the otherside). Stability can be a problem with the short wheelbase. If you...

Yes M-1009. I are spastic .................. Thank you for understanding. Hey i got it in the right section? I think??

Yes i know i need to change the vacume lines. But that should cause different problems. But the truck drives and shiftes fine while it is working. I remember sometimes if a modulator valve goes bad it can send trans fluid to the motor via the vacume line. Interesting about the transfercase...

All stock. This truck runs and drives good. But has a strange problem i just cannot get my head around. Ok so here is my discription of truck. Motor and trans are clean no or negledgable leaks. Changed transmission filter and fluid. Checked vacume hose to modulator no trans fluid there. Vacume...

M-1009 We use it as a service truck. 100 gallon fuel transfer tank where back seat was. Big tool box at rear opposit spare tire. The tailgate makes a great workbench. More tools and parts in rear floor board area. Can jump 12 or 24 volt equipment. Can get to wherever the equipment may be. The...