Search results

i have a M1114 humvee and the belts squeak when i push the accelerator. Any ideas on what to do?

not sure I will just trying to get info. I have some knocking going on and oil pressure gauge in the 10-15 psi when warm. I will be testing the oil pressure at the sender. it runs good going down the road though.

how hard is it to replace oil pump in humvee?

Looking to change my 3 speed in my hummer to a 4 speed OD. Can anyone tell me what i need an where to buy it? Is there one place that i can get it all? Transmission can be used. I have a car lift that my hummer will fit on and wondering how much trouble it will be to change. Thinking about...

yea i have but not sure i like it. they use liquid sandpaper and then prime it. Never used that before and also don't know what type primer to use.

so i purchased some humvee doors from Western Kentucky Surplus. They are the fiberglass ones and are pretty nice. Wanted to know how to prep to paint them. I am using Rapco paints and need to know if i need primer. Do i need to sand them? What grit sandpaper?

yea i am good with 24 volt as the lights i have are 24 volt. Just need to know what wire i can connect to behind dash that is switched.

Just looking for a switched wire in the dash---just to be simple.

where is a easy place to get a switched wire source in the dash or behind the instrument panel. Just going to power some interior LED lights.

awesome, thanks for the helpful info!

trying to hook up a back up camera and place for USB hookup. Best place to get power from? Best item to use to convert to 12volt? Where to mount buss hookup? i assume buss is a place where you can hookup multiple items?

thanks for all the info!

Anybody know how to properly remove windshield wiper arm from a humvee?

so i am used to using lacquer thinner and have that on hand. That will work with the Rapco paint?

Anything new on tan paints for my humvee? What is the easiest to spray?

Do you need to add thread tape to the thermostatic fan switch or install as is.

what penetrating oil do you guys recommend?

i have not tested them yet. Have not purchased any new ones either. Just trying to get ahead. What should they test at? 2 ohms?

Thanks for all the info. Have you guys heard of these glow plugs breaking before you get them out? Read a lot online and wondering if this is common?