Search results

Thanks for the info, I will check those connections. The voltage adjust knob has no effect when I turn it. I would probably get the VR board now, but I wouldn’t want to install it with it over revving the way it currently is.. https://youtube.com/shorts/4c_QD47gUe0?si=e-Gk-q5d5Zjzgq7J

Got the pump back on and everything buttoned up. Started up good after some cranking. Unfortunately, the pump rebuild didn't solve my original problem. The RPM's are still creeping up on their own. Can't get it to maintain a steady RPM. It still seems like an injection pump problem, but...

Ok good, I'll post back how it runs when I get it going.

I got the gasket kit, and I am getting it back together.. I had one quick question, on the #5 spacer I wanted to make sure I put that in correctly. When I removed that VALVE ASSY. #4, there was a black spacer on it. I removed the black one, and slid the new orange one on from the kit on...

Thanks, I'm thinking ill just get the rebuild kit and put it back together. I guess its possible that the erratic RPM's could be a different problem, but sure seemed to be an IP problem. It has always been a good runner. It starts up good, and runs with no smoke at all. Before I pulled...

Got it taken apart, everything came apart easily. Only problem is everything looks good. I was hoping to see a something to validate the problem I was having. I'm thinking of getting a gasket/seal kit if its still available, and putting it back together. The only thing I noticed was there...

Well I haven’t taken it apart yet.. just took out the throttle shaft to check that small pin on the end. I’m hoping I find something wrong it to explain the problem I was having. I’ll update when I get farther into it.

Well getting back to this thread.. I got around to pulling the IP. Also removed the throttle shaft. The pin on the end that Ray mentioned looks to be intact. So looks like I’ll have to dig deeper. I did see the thread here about a complete tear down. I’m not knowledgeable at tearing down...

It does seem to run well and handle a load... I started to notice the problem when I was about to shut down the generator. I would flip the breaker off which would take the load off the genset. The governor would then quickly decrease the throttle with the load gone, but RPM's were not...

Hello, I am having a problem with the injector pump on my MEP-002.. I use this generator off grid so I use it a quite a bit. I bought it with about 500 hrs and I am up to about 3000 hrs now. The problem I am having is the injector pump isn't regulating the RPM's correctly.. Let me try to...