Search results

But that does not explain why the fuel pump does not run when the switch is turned on

starter has 25v and I can jump the starter and the engine cranks fine but no fire

Also the emergency shut off switch has 25v across both lugs

More photos

I cannot find the MT4. I see that it comes off the alternator and I see nothing like this in the engine compartment and nothing labeled inside the control panel box I see a solenoid next to the dead crank switch and some type of white plastic thingy inside the voltage panel I checked the...

About to drive the 2 hrs to the generator and after reading your comments, I have concluded (maybe incorrectly) that the MT4 is the "Battery Charging ammeter Shunt" and that the S10 is the "Dead Crank Switch" . I plan on checking the current and possibly making a jumper wire if the switch is...

Sorry, the ignition switch. It has 25V on the #8Lug. Voltage drops when I turn the ignition switch to start and then leg 3 has like a 6V power running through it and I believe lug7 does as well. Yes the "Battery Charge Ammeter" has the 25V on it's legs. What I didn't check was the voltage...

Yes, firs thing I did was suspect the batteries and I put the Fluke Meter on them and they make 25V at various points on the geneartor. Panel switch included. AMP Meter and other locations I didn't download the -24P parts TM as I didn't know it existed but was starting to think I need to...

WIthin reason. The manuals do not show where things are located only a simple diagram for most of the items. I downloaded the TM on the generator and it uses a block flow chart to explain things but makes no references as to their actual size/location so some things become an adventure to find...

Thank you! Where is the MT4 located on the generator? Currently my batteries go to a plug that accepts an outside power cord with the + on one side of the plug and the - on the other side of the plug. From there (memory) the positive goes to the starter and then smaller wires go to?

No...

I have a MEP-804B (Yanmar Engine) and I have a problem that just developed. I was using the Generator and shut it off for a few minutes and then when I went to restart I get nothing, meaning the fuel pump does not run, the engine will not turn over and thus will not start. History: Unit has...

Anyone know what brand or weight of oil these generators require? TM says 6 quarts of oil but nothing about the grade or viscosity requirements

thanks

Thanks. The valve is not leaking, rather the point where the assembly enters into the side of the generator (tank?)

I purchased an MEP-804B generator and I have just a few general questions if someone can answer. The AM/VM switch, am I incorrect in thinking that this is merely a reading of the ”L” legs and not a switch at all? Meaning it does not turn on/off anything just reads the current across the...