Search results

I bought a stencil maker/cutter from Ebay.... Less than $100... design on computer, put in cardstock, spits out stencil..

Thanks, I'll dig into it some more.

>Anyone got an idea?< ^^^^^^^^^^^^^^

Almost a week, and nothing? Nobody?

You think RRAD did that? Or you think GL/GP (whoever you bought it from) did that? Wouldn't be the first time I've seen employees at auction places rigging the vehicles to fail so they could buy them cheap...or messing up vehicles when they go too cheap..... ****, I paid $900 for an M1010 at a...

I would check and see if Seafoam still advertises it for diesel... I believe there was an issue... Might be a coincidence but I toasted an IP shortly after adding seafoam....and I'm not the only one... May be coincidental, or they were on their way out and I just expedited the process, but...

LOL. It only draws 100A..... Looking to get rid of any? :-p

16.5? For what?

So, I grabbed the TM for the pump, but the pictures are mostly all black and not viewable.. so... Notice leaking from around the throttle shaft area, pulled pump, realized the ether pressure switch attached to the pump is definitely toast, and is definitely leaking, BUT, I have it off so I'd...

I'll be by shortly to liberate those ;)

Hardtop + FL = Put a solar panel or 2 on the roof... 200W of solar will give you about 15A of charging/use...With moderate you'd be able to use a dedicated battery isolated from the charging system, so even if you kill the batt you can still start/run the truck...

They make a self dispensing can, kinda like cheez whiz, and it sets in 2 minutes... https://www.permatex.com/products/gasketing/the-right-stuff-gasket-makers/permatex-the-right-stuff-grey-gasket-maker-3/

Chief buggy... Make sure you get a Q2 on it...

Pulled my PT pump off....Looked like it was leaking from the throttle shaft... I noticed the shaft is super loose.. gravity alone is enough to flop the lever around.. BUT...In doing so... I noticed bubbles coming from the electrical connector that should be the pressure sensor for the ether...

Do you know what a full tank is? LOL Gotta leave room for expansion ;)

No one carries 550 cord? :-p

I know it's 3 years later, but I have the same problem and this thread keeps popping up.. So, for those looking for the O-ring PN, it's Cummins 100478

2cents:razz:

Nice... I saw those... One went for half the price of the other, I LOLd.... Glad someone local got it... In the future, shoot me a PM or post a message on the PNW SS Facebook page....... Someone is always willing to help, and you were a stones throw from Williams oil filter in Tacoma...

Plusnuts will help those looking at a binding solution without using nut and bolt, in areas where access to one side is difficult/impossible. Plusnuts are like Rivnuts on steroids..