Search results

Air cleaner lights up in the run mode. Kris

Air cleaner light? Kris

Where is the air restriction light?

TB101 #1 Tested hot at #5 and #10 in run mode. Ground was on #1 TB101 #2 Tested hot at #5 and #10 in run mode. ground was on #2 TB101 #5 Tested all hot except #9 No wire connected. Red was on #5 The other test I dont understand but will to try to. Kris

Siestas are necessary. I just don't know how are troupes made it with their gear in the middle east. Look at their enemies , they wore designer sheets. I spent 6 years in South america and they taught me how to live. Those were precious times. Siestas and all. Great people. I just wish I could...

Sorry it took so long but a monsoon came thru and cooled everything off. Put everything back together and tested #1 and #3 for continuity. No battery hitched up and stop position = continuity Battery hitched up in stop and run = continuity Start mode = No continuity

I have three German Shepard's what about mag dogs and Germans? Kris

OK I'm in process of reinstalling. In an hour Ill everything back together. My dogs wont even go outside. Not your fault. Got to be done Kris

Bench test pics front and back

This is a schematic for the A4 card. Take it out of the control panel. Use your 24 volt power supply to do the test outlined in paragraph d. But we change it up a bit. With no VDC applied, you test ohms between pins 1&3. Should get continuity. Pins 7&9. Should be open. Then apply VDC and that...

OK I will report back in a couple hours. Glad I can do it in my house. It is hot outside. Kris

Instead of checking the continuity of just the two wires between SP and A9, I checked all of them. All had continuity. No broken wires Kris

I cant believe I graduated to sergeant major. So I get a promotion for being a pupil? Kris

Need to know what wires are they between A9 and SP. Kris

Wire number 45A goes from TB1-10 to S2, pin 3. When the S2 is in the run configuration, then the power should come out on S2 pin 2, wire number P40S. Trace the flow this far. 45A From TB1-10 to S2 in run config has continuity. P40S from pin 3 to pin 2 in run config has continuity. Kris

A1 terminal - No continuity to ground. A1 terminal + with run on No volts Still trying to trace the wires 45A and P40S. Kris

No K1 click 24 VDC at TB1-10 in run mode. By the way, why do you keep me pushing CB1? It never is out. Kris

I remembered that A1 has + and - terminals so I tested in Run and Stop modes. No 24 VCD either position. Kris

Bench tested the two A4 relays to be OK Kris

I could not see the pin numbers so I used the wire numbers to assume the terminal numbers. Ass you me. Kris