Search results

I don't have any factory tank and was planning on running from a 55 gallon drum; can the fuel return be T back into the initial fuel feed line? I'm not sure I have a way to get it back into the drum. Also mine is just a small drip, should it be more coming out of that line? Gen runs good.

Doesn't seem to.be charging the battery with the engine running, has 227 hours on her. What's the best cause of this?

how do i make sure the engine is set at 1800 rpm? is the 60 hertz about 1800?

I will do that, I was checking parts online for that seal to order a new one regardless. And clue of the part number or where I may find a parts diagram for this?

Ran her for a few minutes and there was a puddle of oil, I was able to tighten the oil pan up it had vibrated loose a little, I could not get to the rear bolt (pictured) any tips without a ton of work? Also I don't see a gasket below where the dip stick bolts to the block, it looks like it...

On a separate note, I will definitely ground this one. Do all small generators need to be grounded? I have a few small ones that I haven't even thought about! Is there a minimum gauge wire that needs to be used for a ground? How many feet deep does it have to be put in the ground?

A local electrician said generators by code does not need a ground Rod, there frames are plenty.....thoughts?

Okay, thank you! Will that produce the 220 or the two legs for the 50 amp box? I have this to use with it

Read and watched videos, concluded my brain can't comprehend power systems. Trying to get a 50 amp camper plug to work at 220, all I can get it to do is 110, L1 has 110 with nothing connected, the primary power book said to wire it this way so what am I missing? I only have 110

What wire goes where? 220 plug?

Can you guide me on where to hook these wires for a 50 amp plug

How about the pole switch?

Thank you! What does the switches need to be set on? For this 220/110 , I am using a distribution spider box for now. When my shop is complete I'll use the 50amp rv cable to power the whole shop

Can anyone help me wire this? I have all the diagrams but I am no good at figuring them out.

Thank you! Do you happen to know or can you recommend a proper torque?

What is the largest size oil filter that will fit the spin on conversion? Anyone have instructions on installing, mine came with no documents.....

I am assuming it won't hurt to run them unbalanced: thinking of adding a few more 110 off of the third phase and have a 220 50 amp plug (overkill) going to a distribution block

How would you equally run the three phases? Shop would have more 110 than anything but possibly a 220 generator but never higher voltage. Sent from my SM-N960U using Tapatalk

Thank you for your recommendations! I probably will use a combination of them, last question: Can each phase be used independent of each other? Like 3 separate 110 panels? I'm trying to find something to do with the last lug, I will only need 220 but I hate to waist it if I got it. Sent from...

They had to misquote, I have had mine rebuilt for $58 a piece. Sent from my SM-N960U using Tapatalk