Search results

The heater first started as a (Bergstrom 24v Heater KIT MRAP LVSR Military LVS TRUCK MK48). But after receiving it I found out it did not fit. So not a big deal, all I thought I had to do is cut one side off, make it smaller and reweld it back on. But that did not work. So I scrapped that whole...

Final Got The New Heat All Finished. The new heater pumps out so much heat it melt the hose. So back to the drawing board and this is my new idea for it. But the heater pumps out so much heater I can drive with no doors in the winter now, which is crazy;)

Hey Guys, My (M998) is always hard to start with cold engine in colder weather. I have replace all glow plug last year. I have tested the system by connect a amp meter across the batteries and with the glow plug cycling I see a draw around 89 amps. Also check ohms resistance on all glow plug...

I usually put wood around the tires I am not lifting off the ground and use a large bottle jack in the middle of the axle I am lifting. Then I will lower it on to (2) 10 ton jack stands. I know its over kill, but I feel safe going under the truck this way.

The TM Manual (TM 9-320-209-10-4) Talks about it in chapeter (2-5)

I will nominate my 1967 M35A2

Also made new led tail lights this week. Order toppower 4" round led trailer lights off amazon. Cracked them open and custom designed a new holder for them in the computer. Which I 3D printed and install in the stock m998 enclosure. They are super bright now and very happy the way they came out.

Final fixed the fuel cover door that someone installed before me. Custom design a new aluminum sheet metal one, on the brake today. Also finish installing my new heat that I built for scratch. Worked great today on my first test drive with it. It make so much more heat then the stock little...

Hey Guys, Any one every put Centramatic Wheel Balancer on there M35A2. I have them on my m998 and are a big believer in them. They work great on that vehicle. My M35A2 is on single good years 395/85r20 tires. I was hoping they would remove the shake I get in the wheel at 62MPH when I am...

In

Hey Guys, Need to replace my Plastic Fan On my M998 6.5 non turbo engine. What is the difference between these two fan i have found. Thanks

Hey Guys, What Is this Tapped Hole for on the Rear Lower Control Arm???

Hey Cattlerepairman, What Westach Boost/ EGT Gauges are you using?? Model Number if you have if?

Hey guys, Looking for a new Steering wheel and wanted to know how many types were used and where they all the same size??? I have found two types and the one I have is 20inch OD and I have read that some were 18inch OD. Also any good suggestions to prevent them from cracking over time???

Hey Guys, New to MTVR. But was trying to find out do MTVR have air locker or open diffs in there axles.

Hello all, Have a small question, replaced all my Brakes last year drums, pads and new brake fluid (DOT 5) Purple stuff and they worked great after that. But now this year when I let the truck sit for 2 day or so the brakes Squeaky when you first use them, after that this is no noise. I am...

in