Search results

I’d really like to convert it but if I can’t I’m going to have to try something like that

I will have to do it tmr after work i will have to do it tmr when I get in from work. The pic I sent may or may not be helpful as of right now but will pull the board tmr.

All I need to do is find someone that knows how or that can tell me how

Okay thanks would that be the same if it were to be converted to 120-240v?

This may sound stupid but can I run both house and shop with two separate wires on the same legs ? And would it be loaded that way ? And how much load needs to be on it? Sorry for the dumb questions I’m new to this type of genset.

The shop is fed from my water pump well

That’s what I thought I guess all wire it into the manual throw switch and see what happens it should have a somewhat decent load.

To get a better understanding the third one is the 125v small appliances side correct?

It’s actually getting 125/219.9v

So do you think it fine to tie it to my house at 120/208v ?

Shops have 220v compressors than run everyday one if not two welding machines going sometimes and 3 deep freezers

I’d appreciate it also I do have two shops that it will be pulling as well

It is 12 lead and plan on using it for a back up generator to my house fuel is not an issue I have that on hand 24/7 for machinery

My 006 is new to me just picked up at an auction dirt cheap and runs like a champ just pulling my hair out trying to figure out if it will work like the 004 and 005

I need advice what needs to be done to get 120/240v from my mep 006a 3phase genset it’s currently set on 120/208v I saw a video of it being done on 004 and 005 by cutting the bus bar and jumping t12 to t2 will this work ? Has anyone ever tried or done this any and all advice is appreciated.