Search results

Mine doesn't appear to have one, or it must be in a location I can't locate.

Where is the pcb located on the m35a3? I put in new batteries, but have no headlights and only a click at the firewall. Could this be a bad power switch?

I’m adding Goodyear 395s to my A3, on A3 rims. I love the look of the stone shields. I am not running ctis and have no ctis hardware on these rims. Will adding the stone shields throw my wheels out of balance or not impact them?

I was having the same problem with hard steering and figured out I have strong air presssure to the regulator, but nothing comming out from the regulator. I'm going to bypass the regulator if it won't cause any damage. How much Marvel Mystery or airtool oil should I put in (just a few drops...

I just recieved a M35a3. I've been greasing all the zerts and grease points. Once I got to the Steering Knuckle top and bottom zerts, they seem to be taking tons of grease. How much should I put in these? Enough that it starts to come out? I've put about 50 pumps in each zert and it still...

Thank you!

Thank you for the reply Pokysplace! Yes, I have read all TMs and OMs for this truck, including what you attached and countless forums. No where can I find if having the switch set to "in" or "out" engages or disengages the front wheel drive. Does "in" mean on or off? Does "out" mean on or...

I just got my first a3, and the steering and braking are extremely stiff. Would having front wheel drive engaged cause this? I've looked all over and cant find anything to tell me if "off" or "on" engage the front axle. What should I set it to for the front axle to disengage? Should it feel...

Thank you Scar59!

I have read both M35a3 TMs, the OM and the Lubrication pdf. I have searched this forum and on google, and I cannot seem to find the torque specs for the drain plugs (oil, transmission, front and rear diffs, etc). I've found a great chart that seems to have everything but those. Can someone...

It's not rusted, but won't just twist off by hand. I need to get a socket on it, I just don't have one that big and need to know what size to order. Thank you.

I'm trying to remove the pintle hook on my M998. I need to order a socket large enough to remove the nut holding it on, but I can't find the size mentioned anywhere. Does anyone know what size socket I need? Thank you.

This is the tube coming out of the bottom of my hydro boost that leaks PS fluid. Should this be plugged into something? Should this be draining PS fluid?

I'm adding PS fluid to the PS pump resevoir.

I’ve had my m998 for about 2 months. Over the past few weeks I’ve noticed what appears to be PS fluid leaking onto the floor behind the driver side tire. I’ve followed the leaking fluid up and it is coming from under the hydro boost. I used my phone to take a video, so I could get a good...

Thank you DatGuy. They appear to be bolted in, so I won't use a spring compression tool. I just wanted to double check.

I'm about to tackle this project (replace upper and lower ball joints) on my M998. Do I need to lock down the spring? Not sure if it will shoot off or not. Also, should I remove the half-shaft from the geared hub, or can it stay in? I've seen some pics online of it removed but the TM doesn't say...

I'm about to tackle this project (replace upper and lower ball joints) on my M998. Do I need to lock down the spring? Not sure if it will shoot off or not. Also, should I remove the half-shaft from the geared hub, or can it stay in? I've seen some pics online of it removed but the TM doesn't...

Any EUC updates?

Any shot you have a hmmwv front brush guard?