Search results

I should have added above, here are some links to the filters I ordered; Oil filter - https://amzn.to/3MJHSJk Fuel/Water filter - https://amzn.to/3MIKcjG Fuel filter - https://amzn.to/3WkQysJ

So, after about two hours, I found the issue. Probably was the problem all along. I didn't take a picture, but it was the 90deg 4an fitting at the fuel pickup. I don't recall loosening it at all, but it was loose. So, it was sucking some air. Tightened it up, let it purge, and it ran fine...

I used the fuel drain. Fuel was good. No blow by. I did find a suction leak.

It would run on one, but would be very obvious.

Well, I was hoping that this project would be done, but it taking a not so fun turn. Hoping it's something simple. Replaced filters. As I was letting it prime up, the electric pump made some bad noises. It was the original, and the square ones are not the best, so I figured I would change it...

If I only had something in my shop to do that. One day!

Yes, I fabricated it for the LMHC on my LMTV since I need to get the generators as close to the boom as possible to get in the bed as it's a small crane. Honestly, I have only used it to tug, but will be testing it soon. No doubt it will work great. Made from all scrap stuff. Will share a...

So, Got it all back together. I managed to drive the bearing on a bit more. Put everything back the way it should be. Used a take off, much nicer cover for the generator head that was from a part out unit. I think I mentioned that I saved it earlier in the thread. Used new hardware along the...

This one went the other way around.

So, got the bearing on. But, it's not on quite as far as the other one was. I'm not sure if this is an issue though. To me, it seems like it can be the way it is, as long as it is making contact fully on both surfaces of the bearing to make support. NOTE: In the picture, it's sticking slightly...

It would sequel from time to time. I plan to put the bearing in the end of the housing first, then push it on the shaft all as one unit, that is why I put it in the freezer. So in that case, it is the inner part.

Well, over the past few days, I started working at the bearing change out. Besides annoying, not that bad. Got everything exposed, then off in a total of a few hours. Some of the body hardware needed to be cut off. Stainless wasn't used it seems. Got a puller set from Harbor Freight Tools...

I don't need to keep stacking projects up, but as soon as my A/C kit is installed, I think I will order a set.

Those are for pretty specific applications if I'm not mistaken, so I wouldn't know. I had a 4310 & when looking up the specs, it intended for data. The other is for VHF, but on the low end, for SINGARS. Both are fiberglass so can't be modified like this post shows. Curious if the 4310 would work...

If the price is right, maybe. I'd rather have something proper than modifying something. Message me with some details!

It's not to hard to do yourself, but I get that some people don't want to dive in, or simply don't have the time to do it.

Everyone, I'm offering a rebuild service for $200 of the air hydraulic pump on the FMTV's. This includes the "basic" rebuild kit that 98% need, the rebuild, and shipping back to you. At this point, I have rebuild well over 50 of these. Only one I have no been successful with due to a lot of...

I forgot I already started a thread on it! Can you tell I have to much going on? I have managed to knock a bunch off the list.

Here is a video I made on the upgraded fuel tank well nuts;

Here is a video I made on the upgraded brass tee's;