Search results

Right on thank you.

As soon as I have the old girl in her new resting place the work begins, but no use in sitting around and waiting for her to show up when I can gather all the info now. see what I can dig up and where I can find the correct TM or similar ones, the issue is the wiring diagrams are great for...

Would anyone happen to have a picture of their relay/fuse panel. I know it's a pain to take pictures but a visual would definitely help.

I have been noticing that finding a drive shaft off an old truck is pretty hard, I am kind of cringing at the cost of having one made ha ha but I guess better a new one then nothing.

Good to go, I was casually looking over the 5 Ton yesterday. Really my biggest concern is trying to see if the motor cranks when I receive the truck, I know for the most part the drive shafts are pulled for towing. I have never in my life purchased a used vehicle where all of the fuses and...

Right I knew it had 12 and 24 as well as the 4 pin and 5 pin relays, I just do not know which is which on the board. When I say that all of the fuses and relays were pulled from the passenger side panel I mean it ha ha.

This is pretty amazing!! Thank you.

Hello everyone it has been a while since I last posted to Steel Soldiers, I recently acquired an MTV 6x6 M1093. I did pick this rig up off of Gov Planet and now have the pleasure of getting this truck moved from Washington to California (state soon to change). So to keep this fun and short...

Problem fixed burnt glow plug relay and glow plugs, total cost for repair $100 knowledge learned priceless. NOTE do not wire anything to the glow plug relay.

got my hands on a gp relay so I have read that you can use a different relay like a ford starter relay idk if that is true? I went out and was able to get a heavy duty continuous use starter relay $20 bucks not a huge waste. 85 for a new controller card isnt bad I can do that.

with that being said I have no problem running a toggle switch or push button for gp I would like to keep the original set up with the card however I have heard they are expensive.

lol just set up this name in a rush so i probably have errors, picked up the truck in an emergency situation, unfortunately I understand that nobody will know the wiring situation better than my self I am just looking to see were someone would start in my situation. It looks like someone has...

Hey everyone heres the problem i have an m1009 30,000 miles idk if there original probably not, I was doing some work on her trying to rewire the stereo, and add a cigarette/usb phone charger. Here is were i messed up and could use a little help I ran the positive of these electrical devices...

All of the leads are connected I checked the left lead for voltage and got a reading ,when I checked the right I got nothing when all 3 leads touch the gauge falls below empty all the way to the 9 o clock position when I disconnect the right lead the gauge stays at 3/4 tank. I would use the TM...

Hey guys so I have an m1009 with the 6.2 a couple days ago I pulled the dash to replace all of the dash bulbs (the fuel gauge was working ) that were burnt out. After removing everything to get the dash panel out I had noticed it was covered in dirt and grim so i decided to clean with with...

Hello everyone Kris here just a little back ground I am entirely new to the m1009 Chevy blazer however I was a diesel tech in the military so I know my way around a vehicle here is where the problem lies I can only find military TM's to which don't seem to help my situation due to the fact that...