Search results

I have motors, and just the switch available.

There is an early and late style motor assembly.....Which is it ? Round knob, or T type knob ?

There are only 2 ea. circuit breakers under dash....no fuseable links. CB's are either good or bad. 29 D, and 27 D.....check them un plugged with ohm meter. S3 box should always be changed with sensor............KDS S3 uses CR 2696A,.......Nartron S3 uses 12480779-2. If Batteries are fully...

Everyone should request a full refund.....then they take the turret support and maybe the roof to. Then they start a new auction and bidders will now bid alot less, except the for the guys that have a support.

If you run a winch, Luverne brush guard, jack rails, x or Supl doors...-2 snow plows are fine. 12338316-1 are normal fronts on light trucks.

If its a V belt truck and a regulator is older than 2012, then It gets grounded....[14v tap ].

As I said.....Still need the 2 brackets 12469393-1, and -2. And that pressure regulator is for the diff. cooling...If no coolig diff, then no regulator. There are 3 differnt power steering pumps...Stock GM style with built on tank, and the 2 ea. A2 types with remote reservoir. Early puts out...

Factory original new style is ready to go...no mods or wiring problems with some none OEM part.

That winch needs 2 ea. mount brackets pn. 12469393-1, and -2. You can lose the regulator as its only needed for rear Diff. cooling.

New style sending unit and access cover.

Depends on if : V belt or Early or late surpentine .

Low cargo bows. Wire cover

I have some extra Comtec wires : 506B350-01 4 EA....male / male 506B395-01...1 EA.....male / male 506B348-01...1 EA.....male / female 506B351-01...1 EA......power

As Geico says : even a caveman can do it.

Latches on X doors are the same on the same side.

I have a few PA to RT 10535-0720-B17

Book 10515-0122-4200 has cables that should work.

Been buying from mac for years....never seen them sell used parts....They are a good place.

The ebay separate, wire harness is a relic of the 80's...dont buy it unless doing a NON oem manual system.

The SSI black 12469158-1 box in photo works with temp sensor 12469158-2....either the black top Nartron, or the yellow band KDS. Only Black box that needs no sensor is the Green label KDS.