Search results

Here is a picture of mine

Can you send me a picture of how your relay looks wired? I have holes all in mine and I looked at TM 9-2320-273-20 section 5-25 and want to see if mine maybe wired wrong? New shifter tower, 24v relay. Now I just get no clunks or nothing once I push the button. Last time I was getting the clunk clunk

I just ordered another solenoid incase the one I have is defective, I’ll test it here in a few days too

Hi Loose I jump Off the 2 large terminals. The clicks or clunks sound like starter area

I have a m920 that I replaced the starter, alternator, starter relay, starter push button and batteries. The batteries where old 6TLs and I figured why I was there I’d just replace everting so wouldn’t have to worry about it. I have a new shifter assembly on as well problem is they when I push...

Does anyone have the part number for a unloaded repair kit for a NH250 and a 8.3 thanks

Anyone know a good part number for a NH250 air compressor unloader valve repair kit thanks

Hi Wes it only builds up to 60 and may get up to 80. I put a new air dryer and brake chamber diaphrams in both rears only made a small improvement. This is my first 923

Have a 923A2 with the 8.3 Cummins. new air dryer and brake chamber diaphrams installed. will build up to 60 psi then pretty much stay there. previously would only get 35-40 psi before diaphrams replaced anyone have this issue before?

I tried to send him a message but he isnt accepting

Anyone ever have an issue with their PT pump not responding? I put a brand new pump on, new tanks, lines and fresh fuel and now 5 months later truck will start, only idle and shut off normally. replaced filters (inside pump and on back) which looked good, throttle shaft moves but no response...

Truck has brand new 6TLs, once you cycle ignition switch, starts up normal then repeats, click, no power

Have a 1078 built 2002 that was running normal, parked it then when go to start it runs for a minute than can hear a click then truck loses power. relay shorted?

Anyone have issues getting their A3 started after governor change? I put 8 -10 psi and get fuel in. New shut off solenoid. On the A3 is there any other sensor or switch on the truck? im very familiar with this engine on commercial side. Very rarely worked on the A3 but in other gov prefixes...

Kurt. It was the switch. Just the gov giving me grief now. Magnet wants to pull and shut it off

Here is pic of gage

Hi Kurt 5/16 gap is correct. I put a fluke 77 and measured 0.01 and 0.00 on the L1 and 2 to N

I been restoring this unit and got it started. However I cannot get over 150 volts. I have a new controller card. The unit will also run then stop. Possible gov adjust needed?

Yeah post some pics

Washed and serviced my two.