Search results

Demo of the tank will last for 5 minutes or so but may have a surprise and there will be some viewing of the inside and some description of features. Total time probably an hour.

Sorry the pictures didn't stick

Saw this and wondered what it is? Temperature sensor? Pressure? If so where is the light or gauge?

Looked at pressure line on wrecker today marked 1 and 1/4" so that and 1350 equals what TobyS?

Okay I didn't have time to post then. But don't forget that when you change the fifth wheel the height will change and you will want to leave the spacers out. Also you should change the ramps.

Okay rereading over the thread ferro listed 18 hp at 1800 rpm as factory recommended for the pump on a 936 and I know 1350 psi so I am going to go out on a limb and said a MEP003A will work and now to figure out how to attach it to the system. Munchies how about it any way to attach a shaft on...

Oh by the way TobyS the pressure is set at 1350 lbs and it's a 2" line. Pressure I believe is fact because someone looked it up the two inch is off the top of a different person's head.

So Munchies I could replace the MEP003A motor with a Honda 20 hp and loose like 300 lbs?

Yeah I think you generator figures are for the civilian gensets, and yes they get testy over GL.

Hey bud give me a call and I can help with some answers.

TobyS I think your 50 hp figure will be about right which is why I suggested the MEP003A if I remember right that's about how much that engine puts out. And the pump on the 936 is on the truck but the pump on a 816 is on the crane.

TobyS this is for you the lines on most of the wrecker are 1&1/4 to 1&1/2 in size and that may be underestimated but can get you an accurate size tomorrow as I will be working on one of my wreckers and might even be able to get what pressure they are set for from the guys that actually set them.

I didn't say your math is wrong and didn't wasn't pointing my comments at just you. The crane will not be using any power to hold something while you weld. And no never owned a shop smith but you could use an electrical motor to power the hydraulic systems and use a Welder off of the same APU...

Okay let's stop guessing. I know most of the powered loaders around here use a 4 cylinder so that will get us in the ballpark I know the mep002a is used as a APU on some of the military equipment. Maybe a MEP003A would be a good choice, it could be mounted in place of the spare and part of the...

My post is fact not conjecture this is a EPA caused problem.

Okay m1 tank demo set for 9 am on July 3.

Okay just got word anything already sold is okay but there is going to be a sorting process some of the 939 series trucks will be pulled and have the motor pulled for EPA reasons.

All M series trucks have been pulled by order of DOD

I think the 8.3 with the original 5speed Spicer OD would be nice combo but 5 ton Spicer maybe needed to hold the power.

May have extra pto to sell will count them up. Guys if you have to dump the air to get your TC in and out your lockout is not working the button switch is bad or the actual lockout on the TC has a problem. As for the changing rpm check you air ram you are probably loosing air pressure and that's...