Search results

I don't have them on the front but I do have a double splined and single Overson on my rear and it works great, and very high quality.

If you do part it out I would be interested in the cab top and cargo bed and perhaps some tires.

I'll be there Thursday thru Sunday, I'll have two vendor spots at the end of "C" isle, canopy with camo netting. Bringing the M151A1. Be sure to stop by. Mark Burgess

If you need more I have some as well. Mark

The covers do come in handy and look good but I had one on my truck and drove many miles on them in the military. The big drawback is that it sticks up high and the front really catches the wind, it's like a big sail and you can really feel the wind drag and it's noisy. My unit canned all the...

I would remove the flame heater. I replaced mine with the ether kit. Gets rid of extra hoses, wires, potential leaks etc. When its below freezing all it takes is one flip of the switch while cranking and it starts! Seems there is always someone looking for flame heater parts, sold mine here...

Unless you have a license such as ham radio allowing you to operate on the 6meter band 50-54Mhz its just a boat anchor, looks cool, or acts as a receiver. In that case any radio would work. If you are licensed to transmit on it you might want the power output the 524/246 offers. The...

I believe you should have 20 oz on the drivers side and 16 on the pass.

Patrick, how much were they asking for the GRC-106 stuff? Great pictures!

I will at weare, its the last weekend in July 27-28-29, too far to drive the deuce but I will be towing the M151 down on a trailer. There was a rally in Maine several years ago in Old Town, I had my m151 there and a few showed but not a big turnout. I think Weare is your best bet. Weare is a...

Here is a picture from an earlier post by bjorn on his clutch job, you can see with the wood blocks in place his fingers are in the same place yours are without blocks, I would guess something is wrong. I just got one from Saturn and it had the wood blocks in it. Have not taken mine apart yet.

Looks great! Looking at the dash on the drivers side it looks like the "T" handle of the fuel shut off is broken off, it might be a good idea to bring a new engine stop cable with you, or if the handle is just broken off a vice grip may work untill you can get a replacement cable. Looks like a...

I looked at my pump today and it looks like a "cover" where the FDC should be, does this mean it has been bypassed and covered. Here are a couple of pictures.

Here are a couple of pictures of it installed. I don't have any gauges hooked up, what you see is the ether tube or the plugs for the old flame heater parts. When I said scream I meant whistle of the turbo exhaust. As far as sharing where I got it rebuilt it was from a SS member and I don't...

Ken, runs great and better yet screams like a cat stuck in the exhaust stack! Expect to send you a care package soon.

I found the box of bulbs I had, I will ship one out to you.

After a long and expensive run around(3 turbos to make one) I finally have a fresh rebuilt "C" turbo to install on the deuce. The "D" turbo looks to be a recent replacement and very nice, its going to a SS member who was kind enough to help me get this project on track. Here are a couple of...

I have a Geico policy and when I tried to insure the deuce they said no, had to go to state farm, around $270 a year-no garage.

False alarm, I have to work that day and can't get the day off. I talked with one of the sponsors and they said it was going to be about a 3' deep pit but not sure how soupy. I appreciate all the advice and offers though, still could come in handy some day! My front boots are both leaking so...

I believe I have some, send me a pm. Mark