Search results

Thanks

good soldiers of steel, my gen1 remains on, I have followed the steps to check how gen 1 is located, and in the two red/brown wire connector that with the vehicle without contact they must have: red battery voltage brown 0 with contact on red battery voltage brown 12v and the fat rear red...

What is the size of the rim screws for an M1009? I need a new tire.

I took it directly from the glow plug sensor, one end of the cable to the sensor in the middle of the switch and the other end from the chassis, solutions jjjjjj

I live in the middle of the country, here American military vehicles are not very popular, here what is popular are old vehicles from European brands, or the Spanish brand Seat. Bilbao and Logroño is an area with a lot of charm, the north of the country is beautiful.

The base of the fuel filter began to cause problems, air was entering and the Hulk did not want to start, I detected that it was because of the restriction switch hole and I got to work. I disassembled the Wix filter, took out the filter base, checked all the joints and the restriction switch...

Well, I have had this very stopped, but I have continued working on the m1009, after finally starting it.... I continued doing things I cleaned, sanded everything with the grinder, damn black plastic on the floor, it was difficult to remove it, when the floor was sanded, we applied a rust...

One question, I have a 12v alt output red cable with the key off and on, In the upper red/brown connector I get with the key off: red 0v brown 0v with key on red 0v brown 12v The car's voltmeter shows 28v charging, but the Gen 1 and Gen 2 lights have stayed on. The bulbs are correct 168 and...

Could the temperature sensor on the driver's side rear part be used to install a temperature sensor on the dashboard? and leave the yellow + cable and the black - cable of the sensor without connection, since my GP card is dead and I had to make a manual switch to the glow plug and the wait...

I know this topic has been covered a lot, but when you make the ground cable-push button switch and the other end to the solenoid relay pin where the blue cable from the card goes, is that correct? Or do you have to directly jumper the blue wire on the card and take one wire to the relay and...

I recently acquired some red leather ones from a '84 blazer, they are perfect, but they are not original, or the color of cucv, there is no type of leather/vinyl that has either class or the special color of the cucv, but look at the ones dashboards from summit, lcm, rockauto, they release many...

@cucvrus Do you have any sets of these in good condition? I just need the covers

Today I bought Timken 2043 and this is the correct one, the GM number 26033578 is the necessary one.

This post has been super useful for me to find the replacement for my np208 seal for my m1009, however I bought a timkem 8622 in rockauto for the differential pinion seal 458859 and I am not able to put it in, the replacement is 2mm wider than the hole , and since it has a square piegle, it does...

My GEN 1 light stays ON when you start and stays on when you rpms up

I need this piece, right and left. I dont know its name. with foam or without foam,

unplugged the gen 1 regulator and the gen1 light disappeared, and stayed that way for the 10 minutes The m1009 Was running. The voltmeter always reads 26v, which is half the distance of the voltmeter as it reads 20/26/32v. It arrived when I bought the car. The front and rear batteries give...

.

unplug the regulator and the light go out, the voltmeter continues to show 26v at all times, check 10 minutes

the belt of gen1? I'll loosen it a little and report back.