Search results

You say its an A1 truck. The first drawing is a wtec2 harness found in the A0 trucks. You have a WTEC3 in an A1 truck. The second page is also info on an A0. Now the early A1s are similar to the A0 in many aspects, the documentation you are showing may or may not apply. I cannot get to my...

What year is this truck?

2 full turns Out from contact. You can turn it in from there 1/4 turn trying to to get a useable signal(chapter 7 in the tech manual). I would pull that one out and make sure it isn’t covered with metal shavings, then check proper install. on the ohm check for the sensor the resistance needs...

On the A1 24V battery power is fed to the WTEC III controller by CB43 On the A0 12V battery power is fed to the VIM and WTEC II TCU via CB35. On both models CB79 provides the 24V switched ignition power. What year is this truck?

Yea I would identify the N solenoide wire pair in the transmission harness connector and confirm the short is in the transmisdion before I commitred to pulling the control module.

Its in the operators manual:)

Ign is still cb79, but Iam not recalling where batt power to the trans controller feeds from on the A1.

Needs to be below 750 RPM to shift, had not heard about a difference between D & R, but cool.

98 is probably an A0 with a 3116 engine, the hand throttle makes it an A0...

All the solenoids are in the control module bolted up into the bottom of the transmisdion where the filters are located... This as suggested could be bad wiring at the locations mentioned. For engine issues you need to be specific on year/model of truck. The A0 and A1 have radically different...

Codes stored?

I love it when a plan(and the connector shells) comes together…

Pobe all the holes on the female side and see if one isnt as deep as the others. It is not supposed to happen but sometimes the wire stop in the pin isnt there and the wire gets slid too deep into the pin and crimped. The excess wire then prevemts the male pin in the opposit connector from...

The most expensive part of electric manual is the pressure gauge:)

My wife liked the moon roof, but I am putting the airfilter up there which partly covers it and a fairing which blends it with the habitat...

Sadly you have nothing to troubleshoot. 5 solid lights is an internal fault in the controller. Nothing left for it but to use it as a coaster or a coffee table conversation starter… either replace it with OEM, Plasa’s arduino based unit or go manual like I did(mine was 5 solids when I got my...

does the hazard light switch light? Do the heater control panel lights work? The heater control light power comes from the hazard switch and the two are joined on the truck side of the P/J 913 connector pair. If those lights are working and the aux panel switch lights are not I would look...

That is cool!

Yea the brake shoes can stick to the drums, especially if wet when last parked. They are open brakes, You should be able to see the shoes move in away from the drums when you apply park air(releases brakes), just like you can see the front shoes move outward toward the drum when you step on the...

You could still have a WTEC II in it. My 98 M1079 does… is your trans controller display square with red characters or is it rectangular with green characters? yep, read out any codes, note if the mode light is lit when you read them as this indicates a current fault, not a stored memory… So...