Search results

Wow, talk about dreaming big! Wives have big ears, and they can read SS posts so be very careful.:grd: Oops, I thought you said dear hunting.....

Thanks a bunch! I thought I had it covered and then got the cancelled notices. Found the switch on NAPA and the sensor on Auto Zone. Bruce

Update: Both the dimmer switch and the level switch were not available from gmpartsgiant.com. They just sent cancelation notices for the order. Bruce

A couple of updates for future workers on this project. 1-There is a little steel bracket that holds the aluminum oil tubes to the cowl on the driver side. If you are not aware of it it will fall down on the deck. When reinstalling this little clip which has a nut in the middle and two wings...

Well I am almost done. Oil lines are hooked up and aluminum radiator is in place. The rubber insulation parts do not line up perfectly with the radiator. I think it will be ok but it is a little disconcerting. The passenger side oil lines are a bit puzzling. The top line had an o ring, but the...

Is it necessary or desirable to remove the fan, clutch assm., and shroud, if you are only going to remove and replace the radiator. Any tips or suggestions are very welcome. Thanks, Bruce

I would prefer the steel and copper radiator but I have a situation here where I need to get my daily and only driver back running before the end of the month and I am partly disabeled, Thanks for all the help and advice from everyone and a special thanks to cucvnut. Bruce

Thanks to everyone for your help. I was really starting to get worried since this is my daily driver and my other two trucks are in storage because this city is ....well you fill in the words. I decided to get the aluminum radiator as was recomended. $212 including 2 day shipping. I really...

There's a hole in the bucket dear liza.... I have a major leak in my radiator. If you remove the top plastic cover and look down and to the right half way down just where the fins meet the edge manafold.(Looks like wrinkled paper) I am supposing it is some kind crimped connection. At any rate...

Wow, thanks a bunch. Bruce

Thanks Keith, That was a great description of the break down of the manual organization and it's very helpful. Bruce

Thanks Barrman! aua Well I get the dummy award. For some reason I was convinced they were in the -P manuals along with all the other detailed drawings, and didn't look elsewhere. Now I can stop panicking and get back to work. Bruce

Correction*** I am going crazy, but thanks to barrman I am ok now, problem fixed! I figure I must be really going crazy. I have all of the TM's on my computer and I know that on the last computer I had which had the same TM's that there was wiring diagrams. The typical figure numbers were like...

I can't seem to find the part in the TMs for the switch that controls the high beams. I know that it's operation is described in section 2-16 of the -10, and that it starts at the end of the turn signal lever and winds down the inside of the column and then plugs into some other harness. What I...

That's me. I would sure appreciate it if you could pick the stuff up from Jim for me. I'll be at TP Thur, Fri. and Sat.(20,21,22) Bruce

OOPS, didn't type fast enough. Did you use gasket sealer on the large gasket or just smear with oil? Bruce

There is a small threaded reinforced hole on the side of the pan which I am assuming is for the sensor. comes with a small threaded plug for it. Bruce

Thanks Ken, That clears that up. I actually have the extension. I just didn't realize what it was. Duh Bruce

Thanks guys!, Since the stock filter works, I am assuming that the extension is not a seperate piece, but just by virtue of the tubes built into the bottom, right? I got mine from a fellow SS er, and the instalation manual was missing. Did you use the gasket dry, or did you use some kind of...

Does anyone have one of these cooling pans for the TH400, and if so, what filter are you using with it? Thanks! Bruce