Search results

I got mine about two weeks ago off EBAY for 75.00, looked just like the one I took off. Do a search on ebay for the P/N. Good luck Sorry for posting the Ebay link

Mine needed a new vacuum pump and a new vacuum valve on the IP. New vacuum line and it shifts just fine now.:jumpin:

I had the same problem, the cause was rusted componets for the horn button. Also make sure you reinstalled the retaining clip and it is in the grove. Used steering wheel puller to pull steering shaft up to install clip. Good luck

dash Was your dash a new one or was it a dash cover? You do very good work.

D'rings Could you use the d'ring mounting point for a swing out cairrer?Still learning

My info 1985 M1009 VIN 1G8ED18J0FF120796 REG NF08Y2 NSN 2320011232665 Fort Knox KY Bumper # 189IN BDE Thanks

My truck says 189IN BDE Which will now my State reg number, so I will not need to display a plate on the truck.

Link to glow plug tool GLOW PLUG EXTRACTOR TOOL

My tail gate has the same problem, maybe we had the same driver. There is a post here http://www.steelsoldiers.com/cucv/63962-made-home-my-new-1009-a.html He had the same driver also. But he shows how he fixed his.

It was the Passenger side back rack.

I put in a new vacuum pump will need to get a transmission valve now. Also installed new door locks and Ing tumbler. Took the dash apart and got all gauges working again. Took out the radio rack in the back.

Where did you get the seats, are they covers or new seats? Thanks

Replaced my vacuum pump today, getting good vacuum at vacuum valve. But not getting anything out of valve. I guess the next step will be to pull the vacuum vale and try to pull it a part and clean. Any one have any words of wisdom? ( required TM referance 9-2320-289-20 sec 3-21) Thanks

Can theses items be cleaned with anything?

Try this link http://www.steelsoldiers.com/cucv/47346-so-i-cleaned-ip-valve-fuel-return-line.html

Replaced all the bulbs in the instrument cluster, still have some not working. Will take it back out and check sockets. Replaced ING tumbbler and turn signal lever. Moving forward day by day.

First welcome: Start by reading all you can on this web site, down load the TM's you will need them. I started by cleaning all elec connections and using dielectric grease on connections. They say here if it is rubber replace it, if electric clean it. Good luck with your M1009.

I forgot about McMaster-Carr they carry everything, the shackles would used for 1. Looking right on the truck 2. Getting unstuck or pulling someone out who is stuck. Thank for all the help

So where can I get the bumper shackles for a M1009 or the pins? I have three shackles and two are missing the pins. Tractor supply did not have nor did Rual King. HELPThanks

I did the Doghead relay, have cluster out an going through it, replaced the heater blower switch works great now. Have new key locks to put on, new dimmer switch coming, installed new head light switch. Cleaning connections and grounds.