Search results

Tis how you learn. The only stupid question is the one unasked.

By chance are you talking about that clicking noise before you actually start the engine?

Are you still using the original exciter avr?

Assuming 120\240 mode which is 52 amps 6 awg

Glad you got it going

Other helpful things to look at: pay close attention to the IN and OUT on the filter castings, Ive had these backwards before. change the filters and open the bleed screw on the first filter (center unit) and set the main switch to prime and run. when fuel leaks from the bleeder do the same...

Strainer undo the nut at the bottom of the bowl Filters take the large bolt off on the top center of the housing (think its 5\8) it has a smallwr bolt sticking out of it (1\4) that's also your bleed screw).

No, but I do controls for a living and a place would be easy to install. I did a hybrid to a 004, it's controls are intact but I added a servo and other external sensors. Sent from my SM-S908U using Tapatalk

Make sure your voltage select is 120\240. Then black to l1 white to l3 green to ground.

Need to know what the compressor voltage is. Do you have a multimeter?

wix 51004 if you need an oil filter

sorry had to get back to the office, Amazon, Wix 33511. buy 3 of them. use 1 gasket in the strainer, use the other 2 to replace the filters and gaskets. the unused filter can be used later with the replaced but slightly used gasket

I know for a fact the one from the filter kit will fit I have done it on that exact model

That's the strainer if you order a set of wix filters you can rob one of the gaskets out of the filter kit and use that

Fuel strainer or fuel filter? When you buy the new wix fuel filters they come with a gasket that can be used to replace the top end cast or gasket however they don't just sell the gasket so if you need one for the strainer what I've done in the past is buy a fuel filter and I just reuse the...

Modern problems of shipping. If you dont have it the 24p manual has all the part numbers you could need.

glad it worked. do yourself a favor and buy a can of deoxit. apply a small amount to the resistor windings and sweep it again, this will clean and help protect it from oxidizing again.

Last one I had was 9 days in Florida summer. It was unpleasant

Central FL and inland. Had a branch hit utility. Got about 45 min of runtime. Very glad to have the meps available Sent from my SM-S908U using Tapatalk

Here's the nsn