Search results

You think they recommend only like units because of what I said a couple comments up? If it’s to like generators then obviously the one you’re switching to can handle the load you currently have on the other one. You would just have to be aware of what load was on the 803 before you switched it...

Two reset 802a’s

So I got a pretty good deal on two mounted 802a the other day. This was also mig Ted on the trailer and they were hooked into it. I bought have an 803a already and wanted to get my hands on an 802a for running at night because not much power is used at night. Just a central AC. When I started...

Are you referring to the rectifiers?

Can this 40a alternator from prestolite be use as a replacement provided it has the same moi ting and terminals on it?

I have ordered both rectifiers for back up, whether is a regulator that can fail as well correct? Do you know where to source that?

1/4” ID?

Where can I get -5 an lines for stainless braided I have tried everywhere I can think of. I have the AUX fuel line but I’d rather leave it alone. It is to long for my needs.

Where can I find -5 an hose ends? I have tried summit, jegs, Russell’s, vibrant lol

Can anyone tell me the ID of the copper tube that is associated with this adapter. I picked it up for pretty cheep and figured I would just add it later 🤷🏼‍♂️.

So since this thread has been started has anyone the performed the MOV mod, had a VR diode go out on them?

How did this VR perform after replacing the diodes?

Did you get anywhere with this?

?

Cool I did not know you could manually calibrate it! Tons of knowledge here thank you.

How long is your line, and are you back feeding through a breaker? Mine is 50ft long, figure I would start longer and shorten if Need be. I have to store mine in garage and be able to roll it into driveway when needed.

So I ran my house on my gen set for the whole day since we are coming into hurricane season down here and I wanted to give it a good exercise. The machine worked flawlessly, I am back feeding into my panel through a 60a breaker with 4/4 SOOW cord and a pin and sleeve connector. So once I am...

Do you need to unhook the battery terminals in the unit to charge both separately? Or can you leave them unit all wired and just put them both on? Or can you just break the jump fro one battery to the other?

It will be used strictly for this unit stored in my garage. Undecided where I will mount it, most likely on the wall next to it. This way I will see the status light as I pass by.

So some time has gone by on this thread. I’m curious what’s everyone experience with NOCO vs Battery Tender. I am getting ready to tuck my recently purchased unit away in my garage after putting it through its tests. It will be taken out every couple months and ran until a hurricane hits south...