Search results

Got the Midwest kit installed on the 1088 today. Not a difficult job, but what a difference!

Just finished it today. 1.5" Apitong . Not an advertisement, but I had really good service and quick shipping from Trailerdecking.com.

I have searched thru the forums for the actual TM's for the MEP-007A with no luck. I know the only difference in the A and B is the engine, but I'd still like to have the correct TM. I have just acquired three 007A's, and need to go through and service them. One has a total of 6 hours. I've...

Has anyone ever mated a 8V92TA to an Allison 4500RDS?

M977A2R1 5900 mi. Runs and drives great. What's especially nice is that it'll run 70 down the highway in stock form!! 1996 model overhauled by Osh in 2007. Last painted in 2016 and the bed doesn't have a scratch in it. Even came with almost all BII, including winch and crane remotes. All...

Late 98 model. 4100 mi. Runs and drives great. Now to figure out transmission swap for more speed!

Has anyone with a HET undertaken modifications to get the speed up? Replacing four pumpkins can't be fun, but just curious about any mods. My 55 mph trucks I want to run 65, but I'd be happy getting the HET just up to 55.

Had a welding shop weld a lower pintle bracket for pulling our normal ht. trailers. We don't pull anything extraordinarily heavy. Our intention is to do some testing with various loads and evaluate for any bending and cracking. They used same size steel as what the OEM bracket is made of.

Just got a M1095. These don’t come along too often.

The data plate on my 30-60-100 kw sets say 3 ph 416v. Is there a simple solution to get the output voltage to 480v. I'm not an electrical guru, so any assistance appreciated.

Almost everything on board. Only missing prep side canvas frame rails and the two refrigerators. Needs a good pressure washing inside and out to remove a ton of red sand. I look forward to getting this dude ready to roll.

My 916 tach isn't working. Speedo and overspeed light working fine. Is there any source of new replacements for these? I opened it up and everything looks fine, but for some reason no tach movement.

Is anyone pulling one of these with the stock load? If so, what are you pulling it with? I’m about to get one, and I’m still debating whether to pull it with a M1083 or M934.

I have a chance to get one, but am concerned about drivability, turn radius, maintenance, parts, etc... Anyone care to share firsthand experience?

And what truck does it connect to?

Does anyone know where I could find a rear trailer axle assembly? The part number is D22AX503-209. I'm not having much luck finding it by internet search. It's the rear axle of the 40 ton low boy M870A1.

Apparently the posting police don’t care for me trying to notify people about this event, so just forget it.

I'm curious about the pin size and level height. In the M1088 TM it shows that tractor to be suitable for this trailer. Has anyone pulled one of these with a M916 series? I'm assuming since the fifth wheel height is about the same it should be ok.

I know it's a long shot, but would anyone happen to know a part number or manufacturer of the turn signal switch on the steering column? Mine is bad, as you can feel improper contacting as it moves, and hear slight shorting in the switch. I'm not finding anything just searching randomly...

Would any of you located close to DFW be interested in a 1-day Saturday get together sometime? I’ve got a great place to hold it if there’s enough interest. I don’t have anymore specifics at this time. I’m just gauging if there’s any interest in doing something like it.