Search results

Replace ripped one piece and replace with zipper style on passenger front axle. How long to do you figure. Trying to figure out what to pay my mech buddy to do this.

Ok lets discuss known factual info on the specs of the C/D turbos in here. I want to know the following Compressor MM size Turbine MM size Compressor A/R housing size Turbine A/R housing size Downpipe flange OD/ID Compressor Map

Just changed the filters guessing that 5 years of neglect would have caused it not to rev past 2350 rpm which was about 52-53 mph. Just started the truck after changing all 3 fuel filters and it still looks like it wont rev higher, well at least in idle, havent driven it yet, starting to think...

Is it a 1" socket on the top to remove it? It sure looks like one but the genny is in way, any tricks to this one? Just finished up the secondaries.

Napa 1133 oil on left has 2 gaskets. Napa 3512 on right has 2 large o rings and two small washer gaskets. Are these correct gaskets or not?

I need to build a set of ramps to support a Yamaha YFZ450 quad plus 180 lbs of me. 12' long steel angle iron ramps I called on steel prices and a 20' stick of 1.5x1.5" 3/16 thick is $23.50 Do you feel that this would be strong enough for sub 750 lbs divided by two ramps? Now I have...

How do you remove them I don't want to mess anything up by yanking wires

Does anyone have part numbers for replacement fuel filters, oil filters, and air filters for a multifuel engine? I prefer napa numbers if possible.

Anyone run this and thoughts? I work at a dealership so I have more then I could burn lol

I want to recushion the seats, does anyone sell new canvas covers for them? The fuel cap seems to burp fuel out, assuming seal is bad, where to source as well? The fuel, generator, and air pressure gauges have condensation in them, is there a way to remove the bezel to clean? Last, the red...

Ok Im flying out to buy a truck tomorrow out of Thousand Oaks from a fellow member, I am bringing my portable 150 pc tool kit but I doubt it will fit much on a deuce. What is the size of the Lug Nuts on the wheels, and any other odd ball tools I should take that is not in that kit?

Can it be adapted to standard ball type. What do I need. I'm buying a truck next month so I don't have it yet eye fack

Has anyone made their own up armor kits for a M35? i was thinking about doing ballistic fiberglass panels on the inside of the doors.

Where can I source the parts to add both and what kind of cost are we looking at on a M35A2

Im looking at some GL auctions in KY right now. First question is this, the trucks are said to run, so will GL let me drive it off the lot or it has to be towed off the lot for "loadout", maybe someone can explain that word for me as well. Next question is this, I need to get it back...