Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
http://www.gmfleet.com/content/dam/gmfleet/global/master/nscwebsite/en/Home/Shared_Resources/PDFs/2003LSSVOM.pdf
General Motors LSSV
Military Trucks Owner’s Manual Supplement
The high temp cut out switch (sw4) is in same line, are the shutters working, few minuites is about right without cooling for it to cut off from temp,... just a thought
“Across the board, it is a matter of force protection,” he said. “(A decal) doesn’t always identify a vehicle as belonging to a Department of Defense employee, and just having the sticker can potentially make an individual a target.”...
https://www.rockwellcollins.com/~/media/Files/Unsecure/Products/Product%20Brochures/Navigation%20and%20Guidance/GPS%20Devices/DAGR%20Accessories.aspx
may have some part numbers in it
Thanks, didn't pick up on that, at the risk of highjacking this thread, do any of the parts in photo look familiar , I have some and have not been able to find end item info,
If you have some ATF and acetone you can make a 50/50 mix and put a few drops on the screw to break the bond between...
I have not seen the part you are talking about, but sound like a blind stud of some type.
I have some of these , no tools to install them though if you might like to try, 2cents
4. Conclusions: It is concluded that:
a. Radio Sets AN/VRC-19, AN/FRC-27, and AN/TRC-28 are operationally
suitable for
USAF use as an air base communications system over
"line-of-sight" ranges when the radio path is unobstructed, in temperatures
between...
I think mine may have done that too, used a battery and was working so I did the heat shrink and all plugged in my truck and left turn not working, and found it in the plug,...
Check over the slip ring wires and where they go to regulator and the turns on rotor are common break points, if it's an open rotor or a knick in insulation can give you a low ohm , since you are into it I know you look at it as a challenge , I have not been inside that one , just know looking...