Search results

Cant find TSB for power steering pump cap vent line routing. The 998 has a provision for a vent line. The line is missing on my rig. Sent from my iPhone using Tapatalk

I have an 8274 winch in good running order. Curious if anyone has successfully adapted one to the HMMWV. If so, I might consider the 24V motor/solenoid conversion and give it a go. Sent from my iPhone using Tapatalk

Both are leaking and appear to be using RTV. TSM calls for removal of injector lines and manifold to service. I was hoping to avoid manifold removal. Possible? Sent from my iPhone using Tapatalk

Looking to replace pop rivets on window frame as several are worn/loose. Reading the forum looks like 3/16” but what reach? I gather stainless structural rivets are preferred...? I do not want them to loosen again. Also, PO Rhino-lined the outside of the doors so accessing that side of the...

Replacing the crossover duct to the driver side. Of note the plenum has a foam filler that makes it challenging to r&r the hose. https://youtu.be/6HkpSMromEY Sent from my iPhone using Tapatalk

https://www.6-5liter.com/hmmvwturbokit.html Anyone work with this company or have a review on this or similar retrofits? Sent from my iPhone using Tapatalk

Anyone know the pn or nsn for the rear most board in this listing? https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F323488227334 Sent from my iPhone using Tapatalk

Anyone have diameter and part number for a wear sleeve on the seal surface? Sent from my iPhone using Tapatalk

Purchased inner brackets 12338194... Cant figure out the interchange to know if they fit A0 early style Sent from my iPhone using Tapatalk

My 998 has (3) large holes in the side of the compartment toward the drivetrain tunnel. Any idea what they were for? Temporarily taped them over as it was pulling very hot air into the compartment and cab at speed. Sent from my iPhone using Tapatalk

Looks like an earlier A1 to me. No teardrop hole and back side is completely flat. Sent from my iPhone using Tapatalk

Need a replacement and to re tap welded sleeve. Anyone have the NSN# and size/pitch? Scoured the service and parts TM to no avail this morning... Sent from my iPhone using Tapatalk

Pulling the PTO for sale. Frame clearance is too tight to remove it from the mounting studs. Suggestions for removal without having to pull engine and transmission for access? Sent from my iPhone using Tapatalk

Getting stuck on how to disassemble the shaft joints for inspection and boot repair. I would prefer to disassemble from the hub side as the rotor side outer snap ring looks like a destructive process (its not moving) Rotor side with external ring Hub side. Inner snap ring moved however it...

Anyone know the insulation retainer bar screw size/pitch? Looks like sheet metal thread pitch. I have not made it to the hardware store yet to attempt to match. Sent from my iPhone using Tapatalk

My hmmwv is a 4 man hardtop conversion. Its missing the top tunnel insulation pads and the rear side tunnel pads. All other interior insulation appears to be complete. What part numbers do I need? Ordered 12340870 for the top front 1/2 cover. Sent from my iPhone using Tapatalk

Looking for a source for replacement studs/nuts. I have (6) and expect that the mounting hardware is gone to corrosion. Anyone know where to source outer rings as they seem to suffer as well.