Search results

I thought as much. Am I wrong in seeing the temp sensor bellow the lower radiator hose? There are no other sensors with Canon connectors other than the speed sensor.

The photo just above the one of J5 two wires taped up. The coolant switch only has one wire on it second photograph.

Best I can tell the missing part goes to TB101-18 and TB101-18

Did that still won't stay running

I have chased the disconnected wires down to the J5 plug pins X and y I think hard to see

Disconnected oil switch jumped a to d started machine and it still will not stay running. Question is which is the temp switch also something has been removed

Ok I disconnected the oil sensor

Ok

So regardless of the other tests this definitely needs done right.

Do I need to leave it connected or test it on the bench

This is the a5 board itself I'm testing?

Well I will have to find a 120vdc source for one of the tests. I'll figure something out. Unless that's a typo and it's supposed to be 120vac. Will get the first tests done and get back to you.

Installed the jumper TB101-1 to TB101-9. Started machine, it stays running without battle short on. What does this tell us and where do we go from here? I also had to pull the DC circuit breaker to turn it off.

Ok I'll take the relay box back out install the jumper and hook it all back up and let you know what happens

So when I use the paperclip on s9 is it a to b to c or just a to b

Ok will do this first thing in the morning.

Still won't stay running when I install the jumpers I leave the wires connected as well?

When you press the reset button is it supposed to stay down? It's spring loaded apparently.

Oh it is safty wired do I need to replace the safty wire and is it timed?

This is the speedswitch correct? If I disconnect it will the motor start and run